Abstract:Brick-concrete buildings have been extensively used in urban and rural areas.However,this type of building,which frequently contains a shallow foundation,demonstrates poor struc-tural integrity and is susceptible to influence from ambient vibrations.This case is especially validfor buildings that were constructed in previous eras.With the development of modern cities andthe increasing demand for an enhanced quality of life,environmental interference caused by ambi-ent vibrations has become a critical issue.In areas with soft soil,traffic is a primary source ofambient vibrations.Vehicle vibrations caused by road surface roughness or speed changes cancause vibrations throughout the foundation of a building.Therefore,the vibration of brick-con-crete buildings is related not only to the excitation source of the vibration but also the soil charac-teristics,the foundation conditions,and the structural style.The human response to the vibra-tions of housing structures is closely correlated with a person's cognitive level and their currentphysical and psychological conditions.Thus,the potential difference in the reactions amongbuilding occupants is significant.Residents in a six-story brick-concrete building,which is located in an area of Shanghai withsoft ground,frequently complained about the intermittent interference from vibrations,particularly residents on the upper two stories.The measures confirmed that the environmental vibra-tions were generated by heavy vehicles traveling on a road that was located approximately 80 mnorth of the building.The frequency and amplitude characteristics of the ambient vibrations andthe human comfort levels for the different stories of the building were analyzed according to the"standard for allowable vibration of building engineering"(GB50868-2013).To comprehensivelyevaluate the impact induced by the transversely horizontal vibrations,which influences humancomfort levels for the three components of building vibration,a numerical finite element model(FEM)of the building was developed and analyzed.The soil in the model was simulated as a vir-tual layer.According to the test results and the numerical analyses,two types of technical measures areproposed to reduce unfavorable vibrations.The paper yields the following conclusions:(1)The test results show that heavy-duty vehicles from nearby roads are the main cause ofthe building vibrations.The vertical component of the vibrations along the structure is almostconstant;however,its lateral component is significantly amplified,which primarily influenceshuman comfort.(2)The measures indicate that the peak acceleration range for the top two stories is 68~70dB,which is lower than the limit values proposed by the"standard for allowable vibration ofbuilding engineering"(GB50868-2013).The rationality of the limit values is discussed to satisfythe demand of human comfort.(3)The structural frequencies and modes are analyzed based on the assumption of a virtuallayer of foundation;the simulated results correspond with the measures.The model is a reasona-ble tool for justifying the effect of vibration reduction measures.(4)To ensure that each story of the multi-story brick-concrete building complies with thepreviously recommended standard,the peak lateral acceleration should be reduced by approxi-mately 21% and the two proposed technical measures,which are compared,should be applied.

Vibration Reduction Analysis of an Old Residential District under Vehicle Load

Vibration Reduction for Brick-concrete Buildings in an Old Residential Area

Vibration characteristics and isolation in vibration-sensitive areas under moving vehicle load

An Analytical Solution for Lateral Vibration of a Pile with Finite Length Pile in Viscoelastic Subgrade

Study on Resistance Factor of Saturated Soil Caused by Longitudinal Vibration of Pile

A Study on Longitudinal Vibration Behavior of Inhomogeneous Pile Embedded in Layered Unsaturated Soils

STUDY ON PILE LONGITUDINAL VIBRATION CONSIDERING EFFECT OF UNDERGROUND WATER LEVEL

Environmental vibration induced by vehicle in complicated field

Analysis of vibration properties about two different types of buildings

VIBRATION ANALYSIS OF BASE-ISOLATED BUILDING NEAR URBAN RAIL TRANSIT

Dynamic Impedances and Free-Field Vibration Analysis of Pile Groups in Saturated Ground

Analysis of Vibration Isolation of a Row of Rigid Piles to Plane SV Waves in Saturated Soil

Vibration Serviceability Analysis of Floor Structures under Pedestrian Loads

Influence Of Excavation Unloading On Vertical Bearing Behavior Of Existing Pile Groups

Numerical Analysis of Isolation of the Vibration Due to Moving Loads Using Pile Rows

Numerical Study of Isolation in the Backfill Zone of Foundation Pit Method to Reduce Railway Generated Vibration in High‐rise Buildings

Study of the Micro-Vibration Response and Related Vibration Isolation of Complex Traffic Load-Induced Experimental Buildings

Vibration reduction and isolation performance of a platform foundation and column base of an ancient wooden structure based on the energy transfer analysis

Vibration isolation for moving loads with different velocities by using piles-in-row embedded in an elastic medium

In Situ Test and Numerical Analysis of the Subway-Induced Vibration Influence in Historical and Cultural Reserves

Ambient Vibration Test for a Multi-story Residential Building and the Vibration Mitigation Measures