Abstract:With the rapid development of high-speed railway (HSR) in China, the problem of environmental vibration induced by HSR train has attracted critical concern. In this paper, a combination vibration reduction (CVR) strategy of hollow-closed-wall in-filled trench (HIT) and elastic bearing (EB) is proposed to decrease environmental vibration induced by HSR train, in which the depth of HIT could be well controlled to benefit the practical construction and economic cost. Based on the multi-body dynamics and finite element theory, HSR environmental vibration system is established and then divided into two sub-models including the 'train-track-bridge' vibration source sub-model and the 'pile-soil' vibration propagation sub-model. The two sub-models are connected via the force balance condition of the pier bottom. The verification of numerical models is conducted by comparing with the empirical formula and the ground data in the references. Then the attenuation law of environmental vibration is analyzed, and the vertical component is shown to be dominant in the HSR environmental vibration. On this basis, numerical simulations are performed to analyze the environmental vibration reduction under three strategies, namely the HIT, EB, and CVR. The results show that the HIT presents a distinct vibration reduction effect in the frequency range above 4 Hz and the vibration reduction becomes more obvious as the HIT's depth increases. However, the depth should be larger than 8 m to satisfy the code requirement; the EB presents an obvious reduction in the frequency range above 8 Hz; the CVR strategy not only further decrease the environmental vibration, but also effectively reduce the HIT's depth. By numerical analysis, the combination strategy of 6 m deep HIT and 2200 kN/mm vertical stiffness EB is recommended in the HSR environmental vibration reduction, which could also satisfy the limit of Chinese railway code.

VIBRATION ANALYSIS OF BASE-ISOLATED BUILDING NEAR URBAN RAIL TRANSIT

Vibration characteristics and isolation in vibration-sensitive areas under moving vehicle load

Vibration Reduction Analysis of an Old Residential District under Vehicle Load

Design and Analysis of Crushing Mill Base Vibration Isolation

Base Isolation of Buildings for Subway‐induced Environmental Vibration: Field Experiments and a Semi‐analytical Prediction Model

Analytical Research on a Locally Resonant Periodic Foundation for Mitigating Structure-Borne Vibrations from Subway

Experimental Investigation on the Effectiveness of Laminated Rubber Bearings to Isolate Metro Generated Vibration

Practical Back-Analysis Methodology to Predict Underground Train-Induced Building Vibrations

Study of the Micro-Vibration Response and Related Vibration Isolation of Complex Traffic Load-Induced Experimental Buildings

Analytical Research on the Mitigation of Structure-Borne Vibrations from Subways Using Locally Resonant Periodic Foundations

A Theoretical Investigation on Characteristic Frequencies of Ground Vibrations Induced by Elevated High Speed Train

A Combination Strategy of Hollow-Closed-wall In-Filled Trench and Elastic Bearing for Reducing Environmental Vibration Induced by High-Speed Train

Study of Ground Vibration from Trains Caused by Track Irregularities

Experimental Studies on Three Types of Vibration Isolators for Buildings Near Subways

Predicting the Influence of Vibration from Trains in the Throat Area of a Metro Depot on Over-Track Buildings

Basement Design for Vibration Reduction of High-Rise Buildings under Metro Operation

DYNAMIC ANALYSIS OF BUILDING VIBRATION INDUCED BY TRAIN ALONG RAILWAYS

Studies and Prospects of Train Vibration and Vibration Isolation Based on 2.5D Finite-Element Method

In Situ Test and Numerical Analysis of the Subway-Induced Vibration Influence in Historical and Cultural Reserves

Analysis and Application of Vibration Isolation Technology for a Cultural Center Adjacent to Subway

Development of a three-directional vibration isolator for buildings subject to metro- and earthquake-induced vibrations