Abstract:Solid oxide fuel cell (SOFC) has experienced a growing interest in the last few decades because of generating energy more efficiently than the conventional combustion of fossil fuels. By using the same material as anode and cathode of symmetric solid oxide fuel cell (SSOFC), the production of reliable and repeatable cells would be simpler. In this work, La0.4Sr0.6Co0.2Fe0.7Nb0.1O3-δ (LSCFN) has been investigated firstly as potential cathode material for SOFC. The cathode polarization resistances are only 0.1 Ω cm2 at 800 oC. The stability of phase structure, electrode microstructure and polarization resistances for the LSCFN in the atmosphere of air have been studied. Then, LSCFN have been investigated as potential anode material for SOFC. The results show that LSCFN have high catalytic activity in methane catalytic combustion reaction, the total conversion temperature of 1% CH4 using LSCFN as catalyst was as low as 650 oC. The performance of carbon-resistance and sulfur-tolerance in SOFC were studied using LSCFN ceramic anode with La0.8Sr0.2Ga0.83Mg0.17O3-δ (LSGM) electrolyte. Long-term operation of such single cell under methane lasted for 120 hours without degradation. The output power density fueled with H2-50 ppm H2S was stable enough in 120 hours’ operation which indicated a good sulfur-tolerant performance. Finally, the maximum power densities generated by the SSOFC cell with LSCFN electrode are 650 mW cm-2 in H2, and the cell maximum power output has demonstrated to be not affected by the redox cycling of the anode during a total of 21 cyclic testing, indicating that the LSCFN has excellent redox stability. All of these results indicate that LSCFN can potentially be a promising candidate for the electrode material of SSOFC.

A Comparative Study on Electrochemical Behavior of (la,sr)feo3 and (La,sr)feo3-(La,sr)mno3 Anodes for Solid Oxide Electrolysis Cells

Effect of Coating Solution Concentration on Electrochemical Properties of La0.8Sr0.2MnO3-coated La0.8Sr0.2FeO3 Electrodes

A Comparative Study of Oxygen Reduction Reaction on Bi- and La-Doped SrFeO[sub 3−δ] Perovskite Cathodes

Electrochemical behavior of La0.8Sr0.2FeO3 electrode with different porosities under cathodic and anodic polarization

Investigation of structural, electrical and electrochemical properties of La0.6Sr0.4Fe0.8Mn0.2O3-δ as an intermediate temperature solid oxide fuel cell cathode

Infiltration of La0·6Sr0·4FeO3-δ Nanoparticles into YSZ Scaffold for Solid Oxide Fuel Cell and Solid Oxide Electrolysis Cell

Fabrication and Optimization of La 0.4 Sr 0.6 Co 0.2 Fe 0.7 Nb 0.1 O 3- Δ Electrode for Symmetric Solid Oxide Fuel Cell with Zirconia Based Electrolyte

Tuning Layer-Structured La0.6sr1.4mno4+Delta Into A Promising Electrode For Intermediate-Temperature Symmetrical Solid Oxide Fuel Cells Through Surface Modification

Hollow La0.6Sr0.4Ni0.2Fe0.75Mo0.05O3-δ electrodes with exsolved FeNi3 in quasi-symmetrical solid oxide electrolysis cells for direct CO2 electrolysis

Improved Performance of a Symmetrical Solid Oxide Fuel Cell by Swapping the Roles of Doped Ceria and La0.6Sr1.4MnO4+δ in the Electrode

Synthesis And Characterization Of La0.75sr0.25mn0.5cr0.5-Xcuxo3-Delta For Sofc Anode Material

Oxygen vacancies-rich iron-based perovskite-like electrodes for symmetrical solid oxide fuel cells

Coking-Resistance and Sulfur-Tolerance Study of La0.4Sr0.6Co0.2Fe0.7Nb0.1O3-δ Anode

A Cobalt-Free Electrode Material La0.5Sr0.5Fe0.8Cu0.2O3 − Δ for Symmetrical Solid Oxide Fuel Cells

Enhanced oxygen reduction reaction activity and electrochemical performance of A-site deficient (La0.6Sr0.4)1-xFe0.8Ni0.2O3−δ cathode for solid oxide fuel cells

Electrochemistry of La(0.3)Sr(0.7)Fe(0.7)Cr(0.3)O(3-δ) as an oxygen and fuel electrode for RSOFCs.

Synthesis and characterization of La0.75Sr0.25Mn0.5Cr0.5-x CuxO3-δ for SOFC anode material

Enhancing the steam electrolysis by simultaneously regulating the electron and oxygen ion conductivity of la 1-x sr1+xfeo 4-δ oxides

Electrical and Electrochemical Performances Evaluation of LaNi<sub>0.6</sub>Fe<sub>0.4</sub>O<sub>3</sub> Cathode Contact and Current Collecting Layer in SOFCs

Stability Investigation for Symmetric Solid Oxide Fuel Cell with La0.4Sr0.6Co0.2Fe0.7Nb0.1O3-δElectrode

New Electrode of La<sub>0.75</sub>Sr<sub>0.25</sub>Mn<sub>0.5</sub>Cr<sub>0.5-X</sub>Cu<sub>x</sub>O<sub>3-δ</sub> (x=0, 0.05, 0.10, 0.20) for Symmetric Solid Oxide Fuel Cell