Abstract:Reducing fabrication costs and increasing system performance are the primary objectives of contemporary SOFC developments and research. One of the efficient ways to address the design and durability difficulties is to lower the operating temperatures to the intermediate range (IT, 500–800 °C). La 0.595 V 0.005 Sr 0.4 CoO 3−∂ (LV05SC) perovskite cathode is investigated as a novel cathode for intermediate temperature solid oxide fuel cells (IT-SOFC). Anode-supported YSZ ((Y 2 O 3 ) 0.08 (ZrO 2 ) 0.92 ) and GDC (Gd 0.1 Ce 0.9 O 1.95 ) electrolytes were prepared by a multilayer tape casting and co-firing method. The green bi-layer tapes were co-fired at various temperatures with optimized electrolyte and anode slurries. X-ray Diffraction (XRD) and Scanning Electron Microscopy (SEM) were used to analyze the microstructures and the phase characterizations of the cathode material and single cell. At 1250 °C of the co-firing temperature, as-prepared anode-supported cells showed no defects and excellent microstructural properties such as no gas permeability, porosity, and sintered structure. The electrolytes with a thickness of almost 20 μm were fairly dense. The power densities were evaluated and both anode-supported electrolytes showed good electrochemical performance at intermediate temperatures. The peak power density of the cell reached 89 mW/cm 2 , and the total resistance was only 3.05 Ω.cm 2 under open circuit conditions at 800 °C. The diffusion processes of oxide ions (O 2− ) were found to be the limiting step for ORR by the EIS analysis. These findings suggest that the compound is a promising cathode material for IT-SOFCs.

Oxygen vacancies-rich iron-based perovskite-like electrodes for symmetrical solid oxide fuel cells

Low-temperature Solid Oxide Fuel Cells with Novel La0.6Sr0.4Co0.8Cu0.2O3−δ Perovskite Cathode and Functional Graded Anode

Electrode redox properties of Ba 1−x La x FeO 3−δ as cobalt free cathode materials for intermediate-temperature SOFCs

A Cobalt-Free Electrode Material La0.5Sr0.5Fe0.8Cu0.2O3 − Δ for Symmetrical Solid Oxide Fuel Cells

Gadolinium-doped SrFeO 3 As a Highly Active and Stable Electrode for Symmetrical Solid Oxide Fuel Cells

Cobalt-free Sr0.7Y0.3CuO2+δ As a Cathode for Intermediate-Temperature Solid Oxide Fuel Cell

In situ exsolved Co–Fe nanoparticles on the Ruddlesden-Popper-type symmetric electrodes for intermediate temperature solid oxide fuel cells

Enhanced oxygen reduction reaction activity and electrochemical performance of A-site deficient (La0.6Sr0.4)1-xFe0.8Ni0.2O3−δ cathode for solid oxide fuel cells

Performance evaluation of highly active and novel La0.7Sr0.3Ti0.1Fe0.6Ni0.3O3-δ material both as cathode and anode for intermediate-temperature symmetrical solid oxide fuel cell

High performance and stability of PrBa0.5Sr0.5Fe2O5+δ symmetrical electrode for intermediate temperature solid oxide fuel cells

Preparation and characterization of La1−xSrxNiyFe1−yO3−δ cathodes for low-temperature solid oxide fuel cells

Cerium and ruthenium co-doped La0.7Sr0.3FeO3– as a high-efficiency electrode for symmetrical solid oxide fuel cell

Achieving exceptional activity and durability toward oxygen reduction based on a cobalt-free perovskite for solid oxide fuel cells

Enhancing ORR Catalytic Activity and Electrochemical Investigation of La1−2xBaxBixFeO3 Cathode for Low-Temperature Solid Oxide Fuel Cell

Electrochemical Performance and Stability of Sr-doped LaMnO 3 -Infiltrated Yttria Stabilized Zirconia Oxygen Electrode for Reversible Solid Oxide Fuel Cells

Redox-stable symmetrical solid oxide fuel cells with exceptionally high performance enabled by electrode/electrolyte diffuse interface

Tuning Layer-Structured La0.6sr1.4mno4+Delta Into A Promising Electrode For Intermediate-Temperature Symmetrical Solid Oxide Fuel Cells Through Surface Modification

Developing abundant rare-earth iron perovskite electrodes for high-performance and low-cost solid oxide fuel cells

Fabrication and performance analysis of A-site metal-promoted La0.595V0.005Sr0.4CoO3−∂ perovskite oxides as cathodes for intermediate temperature solid oxide fuel cells

Layered Oxygen-Deficient Double Perovskite GdBaFe2O5+δ As Electrode Material for Symmetrical Solid-Oxide Fuel Cells

Alkaline Metal Doped Strontium Cobalt Ferrite Perovskites As Cathodes for Intermediate-Temperature Solid Oxide Fuel Cells