Abstract:With types of in-house-synthesized multi-walled carbon nanotubes (CNTs) and the nitrates of the corresponding metallic components, highly active CNT-promoted Cu–ZnO–Al2O3 catalysts, symbolized as CuiZnjAlk-x%CNTs, were prepared by the co-precipitation method. Their catalytic performance for methanol synthesis from H2/CO/CO2 was studied and compared with the corresponding CNT-free co-precipitated catalyst, CuiZnjAlk. It was shown experimentally that appropriate incorporation of a minor amount of the CNTs into the CuiZnjAlk could significantly increase the catalyst activity for methanol synthesis. Under the reaction conditions of 493 K, 5.0 MPa, H2/CO/CO2/N2 = 62/30/5/3 (v/v), GHSV = 8000 h-1, the observed CO conversion and methanol formation rate over a co-precipitated catalyst of Cu6Zn3Al1-12.5%CNTs reached 36.8% and 0.291 μmol CH3OH s-1 (m2-surf. Cu)-1, which was about 44 and 25% higher than those (25.5% and 0.233 μmol CH3OH s-1 (m2-surf. Cu)-1) over the corresponding CNT-free co-precipitated catalyst, Cu6Zn3Al1. Addition of a minor amount (10–15 wt%) of the CNTs to the Cu6Zn3Al1 catalyst was found to considerably increase specific surface area, especially Cu surface area of the catalyst. H2-TPD measurements revealed that the CNTs and the pre-reduced CNT-promoted catalyst systems could reversibly adsorb and store a considerably greater amount of hydrogen under atmospheric pressure at temperatures ranging from room temperature to ∼573 K. This unique feature would be beneficial for generating microenvironments with higher stationary-state concentration of active hydrogen adspecies on the surface of the functioning catalyst, especially at the interphasial active sites since the highly conductive CNTs might promote hydrogen spillover from the Cu sites to the Cu/Zn interphasial active sites, and thus be favorable for increasing the rate of the CO hydrogenation reactions. Alternatively, the operation temperature for methanol synthesis over the CNT-promoted catalysts can be 15–20 degrees lower than that over the corresponding CNT-free contrast system. This would contribute considerably to an increase in equilibrium CO conversion and CH3OH yield. The results of the present work indicated that the CNTs could serve as an excellent promoter.

A Novel NiCl2-CuCl2/HMOR Catalyst for Direct Vapor-Phase Carbonylation of Methanol

A Novel NiCl2-CuCl2/HMOR Catalyst for Direct Vapor-Phase Carbonylation of Methanol

Synthesis of N-Methylmorpholine over the Catalyst Cu-Ni-Co/Al2O3 in the Gas Phase

Direct Oxidative Carbonylation Of Vapor Phase Methanol To Dimethyl Carbonate By Cucl2/C Catalysts

A Novel Homogeneous Catalyst Made of Poly(N-Vinyl-2-Pyrrolidone)-Cucl2 Complex for the Oxidative Carbonylation of Methanol to Dimethyl Carbonate

Catalytic Performance of Cu_2(OH)_3Cl Catalysts Supported on Various Supports for Methanol Oxidative Carbonylation

Preparation of Chlorine-Free Cu/AC Catalyst and Its Catalytic Properties for Vapor Phase Oxidative Carbonylation of Methanol

Cu and Zn Bimetallic Co-Modified H-MOR Catalyst for Direct Oxidation of Low-Concentration Methane to Methanol

Preparation of CuIY catalyst using CuCl2 as precursor for vapor phase oxidative carbonylation of methanol to dimethyl carbonate

CO 2 Hydrogenation to Methanol in a Slurry Reactor: Catalytic Performance of CuO-Enhanced In 2 O 3 /ZrO 2

Heterogeneous Carbonylation of Alcohols on Charge‐Density‐Distinct Mo‐Ni Dual Sites Localized at Edge Sulfur Vacancies

Intrinsic kinetics of direct oxidative carbonylation of vapour phase methanol to dimethyl carbonate over Cu-based catalysts

Highly Active and Stable Mixed-Phase In2O3-supported Ni Catalyst for CO2 Hydrogenation to Methanol

Insights Into the one‐Step Dimethyl Ether Carbonylation to Ethanol Over Cu/ZnO@Cu‐MOR Core‐Shell Catalysts with Porogen Engagement

Research on the direct oxidation and carbonylation of vapor phase methanol for DMC production

Highly Active CNT-Promoted Cu–ZnO–Al2O3 Catalyst for Methanol Synthesis from H2/CO/CO2

Methanol Synthesis from CO 2 Hydrogenation on CuO–ZnO–ZrO 2 Prepared by Solvothermal Method: the Influence of Solvent on Catalyst Properties and Catalytic Behavior

High selective catalyst CuCl/MCM-41 for oxidative carbonylation of methanol to dimethyl carbonate

Effect of the Preparation Method on Cu-MOR/g-C3N4 for Direct Methanol Synthesis from Methane Oxidation by Photothermal Catalysis

Surface Structure and Catalytic Performance of Cucl/Sio2-Al2o3 Catalysts for Methanol Oxidative Carbonylation

Nickel-modified in 2 O 3 with Inherent Oxygen Vacancies for CO 2 Hydrogenation to Methanol