Abstract:An SRV friction and wear tester was performed to evaluate the wear behavior of graphite IG-11 used in 10MW high temperature gas-cooled reactor (HTR-10) in sliding against graphite and stainless steel at ambient temperature in air and helium. The worn surfaces of the upper graphite samples sliding against the graphite and stainless lower counterpart were observed using a scanning electron microscope. It was found that the wear behavior of the graphite was closely to the gas environment as it slid against the graphite counterpart. Contrary to the above, the effect of the gas environment on the wear behavior of the graphite became insignificant as it slid against the stainless steel counterpart. This was because the plowing of the graphite by the hard stainless asperity played a dominant role for the graphite-stainless steel pair. At the same time, the differences in the wear resistance and worn surface features of the graphite samples in different gas environments conformed to the differences in the shape and size of the corresponding wear debris. Namely, the graphite sample was dominated by abrasive wear in helium environment, which corresponded to a large wear rate of the graphite and small size of the wear debris. While in air environment, the graphite was characterized by fatigue wear, which corresponded to a small wear rate of the graphite and large size of the wear debris as compared in helium.

Theoretical Analysis on the Tribological Properties of HTGR-10 Graphite

A Comparative Investigation of the Tribological Behavior and Wear Mechanism of Bronze-graphite Composite under Dry- and Water-lubricated Sliding Against Steel

The influence of roughness on tribological properties of nuclear grade graphite

The Wear Properties of Nuclear Grade Graphite IG-11 under Different Loads

Achieving Controllable Friction of Ultrafine-Grained Graphite HPG510 by Tailoring the Interfacial Nanostructures

Nuclear Graphite Wear Properties and Estimation of Graphite Dust Production in Htr-10

Investigation of Topographical Characteristics and Tribologic al Behavior of Compacted Graphite Iron in Sliding against 40Cr Steel under Different Dry Sliding Conditions

Influence of a Carbon-Based Tribofilm Induced by the Friction Temperature on the Tribological Properties of Impregnated Graphite Sliding Against a Cemented Carbide

Effects of Graphite Contents on the Microstructure Evolution, Mechanical Properties and High Temperature Tribological Behavior of Cu–Ni–Al/Gr Solid-Lubricating Composites

Current Status and Future Prospect of Researches on the Frictional Properties of Graphite for High Temperature Gas-Cooled Reactor

Wear Behavior of Graphite IG-11 in Different Gas Environments

Tribological Properties Differences of Various Graphite Used in 10 MW High Temperature Gas-cooled Reactor

Wear Mechanism and Three-phase Synergistic Effect of Self-mated SiC/Si/Graphite Composites in Unlubricated Sliding

The Tribological Properties of Solid Lubrication Graphite Coatings Prepared by a Sol-Gel Method

Friction and wear performances of impregnated graphite in ring-on-ring tribological test

On the tribological behaviors of Cu matrix composites with different Cu-coated graphite content

Research on Friction and Wear Behaviour of Graphite/Antimony Composites

Humidity-dependent lubrication of highly loaded contacts by graphite and a structural transition to turbostratic carbon

Tribological Behavior of Phenolic Resin-Based Friction Composites Filled with Graphite

Influence of Graphite Morphology and Chromium Content on Tribological Properties of Cast Iron under Dry Sliding

First-Principles Study of the Friction and Wear Resistance of Graphene Sheets