Abstract:The abrasive jet finishing process with wheel as restraint is a kind of compound precision finishing process that combined grinding with abrasive jet precision finishing, in which inject slurry of abrasive and liquid solvent to zone between grinding wheel and work surface under no radial feed condition when workpiece grinding were accomplished. The abrasive particles are driven and energized by the rotating grinding wheel and liquid hydrodynamic pressure and increased slurry speed between grinding wheel and workpiece surface to achieve micro removal machining. In the paper, the process technique on abrasive jet finishing process with wheel as restraint wassinvestigated. The effects of different particle size, abrasive concentration, machining cycles, the velocity of grinding wheel and medium type on surface roughness were analyzed. Experiments were performed with plane grinder M7120 and workpiece material Q235A and 45# steel. The machined surface morphology was studied using SEM and the microscope and microcosmic geometry parameters were measured with TALSYURF5 instrument. The experimental results with 10% abrasive concentration, W7 Al2O3 particle and machining 20 similar to 30 circles show that the novel process method, not only to attain higher surface form accuracy, to diminish grinding defects such as severely deformation, surface layer pollution and ground burnout, but also to can acquire efficiently defect-free finishing surface with R(a)0.15 similar to 1.6pm and finally achieve high efficiency, high precision and low roughness values, furthermore, Integrating grinding process and abrasive jet finishing process into one features.

Principle and Applications of Grinding Wheel Regenerator

Theoretical Generalization and Research on the Mechanism of the Unsteady-State Grinding Technique

Investigation of the Grinding Wheel Air Boundary Layer Flow

Numerical Investigation of the Evolution of Grit Fracture and Its Impact on Cutting Performance in Single Grit Grinding

Study on Mechanism for Material Removal and Surface Generation by Molecular Dynamics Simulation in Abrasive Processes

Wear Characteristics Evolution of Corundum Wheel and Its Influence on Performance in Creep Feed Grinding of Nickel-Based Superalloy

Experimental Study of the Correlation of Flexible Abrasive Grinding Parameters

On-line Recycling of Abrasives in Abrasive Water Jet Cleaning

The Study of the Appropriate Reclamation Method for the Complete Reclamation of the Used Clay Sand

Application of 3-D Drucker-Prager Material Model to Determine Optimal Operating Parameters of Centrifugal Regeneration Device

Design of Robust Grinding Wheel Reciprocating Arrangement for Precision Point-Grinding Machining

Study on flow field and convective heat transfer characteristics in grinding zone of large spiral angle flow disturbance grooved wheel

Experimental Investigations Into Abrasive Jet Precision Finishing With Grinding Wheel As Restraint (Id : 3-021)

Simulation and Experimental Research on Airflow Movement Characteristics of Grinding Zone

Simulation and experiment study for aero-engine turbine blade grinding descaling with single grain

Exploitation and Application of Experimental Small-scale Negative Pressure Fluidized-bed

Modeling and simulation of air flow field in high-speed grinding

Removal of Aluminosilicate Bond and Process Optimization on Recovery of Sol Gel Alumina Abrasive Grain from Abrasive Industry Waste

Wheel Wear-Related Instability in Grinding of Quartz Glass

Investigation on Material Removal Rate in Rotation Grinding for Large-Scale Silicon Wafer