Abstract:The peripheral surface of the grinding wheel can grind the rail according to the envelope of the contour of the rail surface, thus a fuller and smoother rail surface can be obtained. Specifically, a better grinding effect can be obtained in that the end face of the grinding wheel deviates from the longitudinal section of the rail at a certain angle. Based on the traditional grinding technology theory, the mathematical models of the peripheral grinding parameters (kinematic contact arc length, wheel-rail grinding contact area, and maximum undeformed chip thickness) and the grinding force are established, in which the angle exists between the grinding wheel end face and the rail longitudinal section. The main influence of grinding wheel circumferential speed, grinding wheel kinematic speed, and the deflection angle of the grinding wheel end face on the grinding parameters and the force are analyzed. The result shows that: when there is angle θ in the models, the ratios of peripheral grinding parameters between up-grinding and down-grinding varies monotonically with the increase in vm, and their maximum variation range is about 12%, vs has the greatest influence on the peripheral grinding parameters, and the maximum variation range of the ratios is about 20% when the vs is 10 m/s. With the increase in the grinding width, Fa' cannot be ignored and will increase gradually with the increase in angle θ. The analysis and conclusion have guiding significance for the structural design, grinding control strategy, and experimental research regarding rail curved surface grinding equipment.

Investigation of the Grinding Wheel Air Boundary Layer Flow

Theoretical Analysis of Temperature Field in Surface Grinding with Cup Wheel

Theoretical Generalization and Research on the Mechanism of the Unsteady-State Grinding Technique

Research on the Analytical Thermal Model in Surface Grinding by Cup Wheel

Study on Mechanism for Material Removal and Surface Generation by Molecular Dynamics Simulation in Abrasive Processes

Simulation and Experimental Research on Airflow Movement Characteristics of Grinding Zone

Into the boundary layer behavior of segmented grinding wheels and its illustration on Ti6Al4V

An Experimental Investigation of Groove Control for Reducing Drag in a Flat Turbulent Boundary Layer

Theoretical and experimental investigation into the formation mechanism of surface waviness in ultra-precision grinding

Modeling and Simulation of Temperature Field in High-Shear and Low-Pressure Grinding with Liquid-Body-armor-like Grinding Wheel

Investigation of the Ball Wear in a Planetary Mill by DEM Simulation

Experiment and Simulation of Liquid Film Flow Driving Abrasive Particle Dispersion on the Surface of a Rotating Disk

Investigation of the contact temperature during face grinding with a new design wheel in order to increase its efficiency

Theoretical Analysis of Grinding Wheel Deflection Angle on Peripheral Grinding Parameters and Grinding Force

Study of the Mechanism Governing the Flow and Heat Exchange Inside a Turbine Wheel Disk-formed Chamber

Experimental Investigation of the Particle Distribution of Gas-Solid Turbulent Flow in the Boundary Layer

Analysis of Flowing Characteristics of Abrasive Flow Machining in Slit

A Study of Investigation of the Clearance Effects Between Blades and Hub of Water Wheel Using Experimental and Numerical Analyses

Experimental study on energy partition of polishing aero-engine blades with abrasive cloth wheel

Optimal Design and Performance Evaluation of Grinding Wheels with Triply Periodic Minimal Surface Lattice Structure

Analysis of the material removal and heat transfer during internal cooling grinding of GH4169