Abstract:In the case of desulfurization and spheroization of cast iron using the in-mold method, in which the treated cast iron is poured into the reaction chamber and placed in the casting mold, the mineral raw material of the mold should support these processes. Therefore, it is important to know the physicochemical properties of the materials selected for the production of casting molds and to learn about the phenomena occurring during their pouring. The research presented in this paper was carried out on quartz, magnesite, chromite, and olivine sands. The results not only provide a comprehensive understanding of these materials but also have significant implications for reactor housing casting. Two of the three tested quartz sands meet all the standards, allowing quartz raw materials to be foundry sands. Marked by the authors of this work, P11 sand, which is classified as 1K grade by the seller, does not meet the requirements of the Polish standard PN-85/H-11001 for this grade and should be classified as 2K grade. At the same time, attention was drawn to relatively considerable weight losses at 1350 °C for the tested quartz raw materials. More significant losses on ignition were found for magnesite sand than the value permitted by the Polish standard, which should be associated with the fact that derivatographic tests were carried out in an oxidizing atmosphere. In the analysis made for olivine sand, the obtained data indicated that the magnesium content is slightly below the requirements of the relevant standard; on the contrary, the iron content exceeds the standard requirements. Analytical data obtained for chromite sand indicated that it meets the PN-91/H-11007 standard regarding chemical composition, but X-ray diffraction tests showed that the tested sample is not chromite but magnesiochromite. The results of grain size distribution, chemical composition, X-ray diffraction, SEM/EDS, and TG/TG presented in this paper show that before starting the production of a specific molding mixture, each time most of the parameters characterizing sand used should be controlled because the properties may differ from the manufacturer's declaration.

Application of 3-D Drucker-Prager Material Model to Determine Optimal Operating Parameters of Centrifugal Regeneration Device

Economic and Environmental Aspects of Applying the Regeneration of Spent Moulding Sand

Investigation of Spent Moulding Sand Using Thermal Treatment with Regard to the Possibility of Recovering Quartz Matrix

Evaluating the Appropriateness of Selected Foundry Sands for the Casting of Reactor Housings: A Study Based on Physicochemical Characterization Outcomes

Recycled sand for sustainable 3D-printed sand mold processes

Regeneration of used sand with sodium silicate binder by wet method and their core manufacturing

3D numerical simulation of high pressure squeezing process with revised Drucker Prager/Cap model

Using a Model Created Using a 3D Printer to Mould a Grey Cast Iron Casting

Experimental Construction and Validation of Revised Drucker–Prager Model Using Finite Element Method for Moisture Condensation Zone in Bentonite-Bonded Silica Sand

Physical and chemical characteristics of after-reclamation dust from used sand moulds

A Novel Reclamation Method of Chemical–Mechanical Grinding for Inorganic Binder Waste Sand in Aluminum Alloy Casting Process

Non-conventional mold design for metal casting using 3D sand-printing

Digital High-Efficiency Print Forming Method and Device for Multi-Material Casting Molds

3-D modeling reactive molding processes: From tool development to industrial application

Promoting sustainability in 3D printed sand casting through adaptive sand mold structures

Principle and Applications of Grinding Wheel Regenerator

Numerical Simulation of Sand Casting of Stainless Steel Pump Impeller

Method for evaluating the resource, energy, and environmental impact of the casting fault rectification process in patternless sand castings

Modelling of shrinkage cavity defects during the wheel and belt casting process

Numerical Modeling of a Sustainable Solid-State Recycling of Aluminum Scraps by Means of Friction Stir Extrusion Process

Effect of freezing range on reducing casting defects through 3D sand-printed mold designs