Abstract:The in-line control of curing during the molding process significantly improves product quality and ensures the reliability of packaging materials with the required thermo-mechanical and adhesion properties. The choice of the morphological and thermo-mechanical properties of the molded material, and the accuracy of their determination through carefully selected thermo-analytical methods, play a crucial role in the qualitative prediction of trends in packaging product properties as process parameters are varied. This work aimed to verify the quality of the models and their validation using a highly filled molding resin with an identical chemical composition but 10 wt% difference in silica particles (SPs). Morphological and mechanical material properties were determined by dielectric analysis (DEA), differential scanning calorimetry (DSC), warpage analysis and dynamic mechanical analysis (DMA). The effects of temperature and injection speed on the morphological properties were analyzed through the design of experiments (DoE) and illustrated by response surface plots. A comprehensive approach to monitor the evolution of ionic viscosity (IV), residual enthalpy (dHrest), glass transition temperature (Tg), and storage modulus (E) as a function of the transfer-mold process parameters and post-mold-cure (PMC) conditions of the material was established. The reliability of Tg estimation was tested using two methods: warpage analysis and DMA. The noticeable deterioration in the quality of the analytical signal for highly filled materials at high cure rates is discussed. Controlling the temperature by increasing the injection speed leads to the formation of a polymer network with a lower Tg and an increased storage modulus, indicating a lower density and a more heterogeneous structure due to the high heating rate and shear heating effect.

3-D modeling reactive molding processes: From tool development to industrial application

Simulation of Reinforced Reactive Injection Molding with the Finite Volume Method

An approach to couple mold design and on-line control to manufacture complex composite parts by resin transfer molding

Modeling Approach for Reactive Injection Molding of Polydisperse Suspensions with Recycled Thermoset Composites

Optimizing Epoxy Molding Compound Processing: A Multi-Sensor Approach to Enhance Material Characterization and Process Reliability

Analysis and Optimization of the Silicone Molding Process Based on Numerical Simulations and Experiments

Creating material data for thermoset injection molding simulation process

Unsteady Disposable Flow Tracking Using Discrete Phase Model

Development and Application of a Cooling Rate Dependent PVT Model for Injection Molding Simulation of Semi Crystalline Thermoplastics

A Global Approach to Modeling Injection Molding

Numerical Simulation and Process Optimization of a 3D Thin-Walled Polymeric Part Using Injection Compression Molding

Residual stresses, shrinkage, and warpage of complex injection molded products: Numerical simulation and experimental validation

Injection molding simulation of short fiber reinforced thermosets with anisotropic and non-Newtonian flow behavior

Optimization of the Compression (Injection/Compression) Molding Process Using Numerical Simulation

Process-informed simulation of Big-Area Additive Manufacturing (BAAM) of polymers

3D Simulation of Residual Thermal Stress and Shrinkage in Plastic Injection Molding

An experimental validation study of a numerical modeling approach to predicting post-consolidation dimensions of thermoplastic composites

Optimization of the cycle time in resin transfer molding process by numerical simulation

Process Simulation-Based Design, Mold Construction and Mechanical Performance Evaluation of an Insert-Injection Molded Thermoplastic Polyurethane Part

Research Progress in Numerical Simulation of Fiber Reinforced Thermosetting Resin Matrix Composites Molding Process

Injection molding simulation with solid semi-crystalline polymer mechanical behavior for ejection analysis