Experimental Investigations Into Abrasive Jet Precision Finishing With Grinding Wheel As Restraint (Id : 3-021)

Li Changhe,Yang Binjiu,Cai Guangqi

2006-01-01

Abstract:The abrasive jet finishing process with wheel as restraint is a kind of compound precision finishing process that combined grinding with abrasive jet precision finishing, in which inject slurry of abrasive and liquid solvent to zone between grinding wheel and work surface under no radial feed condition when workpiece grinding were accomplished. The abrasive particles are driven and energized by the rotating grinding wheel and liquid hydrodynamic pressure and increased slurry speed between grinding wheel and workpiece surface to achieve micro removal machining. In the paper, the process technique on abrasive jet finishing process with wheel as restraint wassinvestigated. The effects of different particle size, abrasive concentration, machining cycles, the velocity of grinding wheel and medium type on surface roughness were analyzed. Experiments were performed with plane grinder M7120 and workpiece material Q235A and 45# steel. The machined surface morphology was studied using SEM and the microscope and microcosmic geometry parameters were measured with TALSYURF5 instrument. The experimental results with 10% abrasive concentration, W7 Al2O3 particle and machining 20 similar to 30 circles show that the novel process method, not only to attain higher surface form accuracy, to diminish grinding defects such as severely deformation, surface layer pollution and ground burnout, but also to can acquire efficiently defect-free finishing surface with R(a)0.15 similar to 1.6pm and finally achieve high efficiency, high precision and low roughness values, furthermore, Integrating grinding process and abrasive jet finishing process into one features.