Abstract:The abrasive jet finishing process with wheel as restraint is a kind of compound precision finishing process that combined grinding with abrasive jet precision finishing, in which inject slurry of abrasive and liquid solvent to zone between grinding wheel and work surface under no radial feed condition when workpiece grinding were accomplished. The abrasive particles are driven and energized by the rotating grinding wheel and liquid hydrodynamic pressure and increased slurry speed between grinding wheel and workpiece surface to achieve micro removal machining. In the paper, the process technique on abrasive jet finishing process with wheel as restraint wassinvestigated. The effects of different particle size, abrasive concentration, machining cycles, the velocity of grinding wheel and medium type on surface roughness were analyzed. Experiments were performed with plane grinder M7120 and workpiece material Q235A and 45# steel. The machined surface morphology was studied using SEM and the microscope and microcosmic geometry parameters were measured with TALSYURF5 instrument. The experimental results with 10% abrasive concentration, W7 Al2O3 particle and machining 20 similar to 30 circles show that the novel process method, not only to attain higher surface form accuracy, to diminish grinding defects such as severely deformation, surface layer pollution and ground burnout, but also to can acquire efficiently defect-free finishing surface with R(a)0.15 similar to 1.6pm and finally achieve high efficiency, high precision and low roughness values, furthermore, Integrating grinding process and abrasive jet finishing process into one features.

Study on Machining System of Precision Micro Abrasive Water Jet and Polish Experiment

Study on Pre-Mixed Micro Abrasive Water Jet Machining System

Study on the Machining System of Abrasive Micro-water Jet

Study on Polishing Technology for Hard-Brittle Materials by a Micro Abrasive Water Jet

Research Status of Micro Abrasive Water Jet Machining Technology

An Experimental Research on Abrasive Water Jet Polishing of the Hard Brittle Ceramics

Particle collision-based abrasive flow mechanisms in precision machining

Study on Jet Formation and Modeling for High Pressure Abrasive Water-Jet

Experimental Investigations Into Abrasive Jet Precision Finishing With Grinding Wheel As Restraint (Id : 3-021)

Experimental Research on Water-Jet Guided Laser Processing

Erosion Mechanism of Ultrasonic Vibration Abrasive Waterjet in Micro Machining

Abrasive Jet Polishing Utilizing the Synergistic Effect of Ultrasonic Pulse-Cavitation and Process Optimization Research

An Experimental Study on the Kerf Characteristics of Silicon Cut with Micro Abrasive Air Jet

Design of the Atmospheric Pressure Low Temperature Plasma Polishing System for the Machining of Ultra-Smooth Surfaces

Theoretical and Experimental Investigation on a Novel Cavitation-Assisted Abrasive Flow Polishing Method

Micro-milling tool mark removal mechanism by fluid jet polishing and its application for the precision manufacturing of micro-fluidic chip molds

Design of the Atmospheric Pressure Plasma Polishing System for Machining of Ultra Smooth Surface

Numerical and experimental study on cavitation enhancement of ultrasonic coupled abrasive jet polishing

Polishing Of Ultra Smooth Surface With Nanoparticle Colloid Jet

A Study on Erosion Performance of Monocrystalline Silicon in Ultrasonic Vibration-Assisted Abrasive Water Jet Machining

Deterministic Magnetorheological Jet Polishing Technology