Abstract:The microfluid jet polishing (MFJP) process is a manufacturing technology in which small abrasive particles (such as diamond, alumina, and ceria) are premixed with a carrier fluid (typically water) to form a liquid suspension that is pressurized and expelled through a nozzle for material removal. The resulting microjet beam—with a typical nozzle exit diameter in the range from 0.1 to 1.0 mm—impinges the workpiece surface for material removal by erosion and/or abrasion and produces an ultraprecision surface. This work applies a computational fluid dynamics (CFD) model to analyze the key phenomena in the interaction of the liquid suspension and the workpiece surface. The liquid film characteristics (film height, minimum film height, positions of the minimum film height, and hydraulic jump) obtained from the CFD simulations are compared with the results derived from empirical formulations found in the literature. Subsequently, the numerical results are utilized to investigate the impact velocity, pressure distribution, and shear stress caused by the suspension on the workpiece surface. It is observed that the shear stress strongly depends on the injection pressure of the liquid suspension and is weakly dependent on the abrasive suspension concentration (the liquid suspension with different densities, viscosities, and surface tensions). Additionally, the particle behavior is investigated in order to estimate the impact velocity and to identify the impact and erosion zones of the liquid suspension on the workpiece surface. Numerical results indicate that ~50% of total particles are impinging the workpiece surface almost perpendicularly (with a mean impact angle of ~86 degrees) for the first time in the stagnation region, where they are strongly decelerated by the carrier fluid before they reach the workpiece surface. These particles, however, rebound on the surface and are reaccelerated by the carrier fluid, impinging the workpiece surface further in the radial direction.

Micro-milling tool mark removal mechanism by fluid jet polishing and its application for the precision manufacturing of micro-fluidic chip molds

Modelling of surface morphology and roughness in fluid jet polishing

Maskless fluid jet polishing of optical structured surfaces

The Influence of Impact Angle on Material Removal in Fluid Jet Polishing

Surface generation modelling and form maintenance strategy in maskless fluid jet polishing of structured array surface

Towards an Understanding of Multiphase Fluid Dynamics of a Microfluid Jet Polishing Process: A Numerical Analysis

Surface integrity and material removal mechanism in fluid jet polishing of optical glass

Novel cavitation fluid jet polishing process based on negative pressure effects

Removing single-point diamond turning marks using form-preserving active fluid jet polishing

Modeling and analysis for material removal and surface roughness in fluid jet polishing of optical glass

Analysis and optimization of microchannel array precision grinding processes with micro-structured micro-grinding tool

Theoretical and experimental investigations on conformal polishing of microstructured surfaces

Polymer Microchannel and Micromold Surface Polishing for Rapid, Low-Quantity Polydimethylsiloxane and Thermoplastic Microfluidic Device Fabrication

Process chain for the mass production of polymeric microfluidic chips

Ultra-precision Manufacturing of Microlens Arrays Using an Optimum Machining Process Chain

A novel approach of jet polishing for interior surface of small grooved components using three developed setups

Numerical Simulation of the Nanoparticle-Surface Collision in a Liquid Jet and Its Effects on Material Removal

Numerical and experimental investigation on the material removal profile during polishing of inner surfaces using an abrasive rotating jet

Experimental investigation of edge preparation for cemented carbide profile cutting tools using flexible abrasive jet polishing

Process Planning And Tool Design Of Magnetorehological Jet Finishing

A high-fidelity digital twin approach for the optimisation of fluid jet polishing process