Abstract:The microfluid jet polishing (MFJP) process is a manufacturing technology in which small abrasive particles (such as diamond, alumina, and ceria) are premixed with a carrier fluid (typically water) to form a liquid suspension that is pressurized and expelled through a nozzle for material removal. The resulting microjet beam—with a typical nozzle exit diameter in the range from 0.1 to 1.0 mm—impinges the workpiece surface for material removal by erosion and/or abrasion and produces an ultraprecision surface. This work applies a computational fluid dynamics (CFD) model to analyze the key phenomena in the interaction of the liquid suspension and the workpiece surface. The liquid film characteristics (film height, minimum film height, positions of the minimum film height, and hydraulic jump) obtained from the CFD simulations are compared with the results derived from empirical formulations found in the literature. Subsequently, the numerical results are utilized to investigate the impact velocity, pressure distribution, and shear stress caused by the suspension on the workpiece surface. It is observed that the shear stress strongly depends on the injection pressure of the liquid suspension and is weakly dependent on the abrasive suspension concentration (the liquid suspension with different densities, viscosities, and surface tensions). Additionally, the particle behavior is investigated in order to estimate the impact velocity and to identify the impact and erosion zones of the liquid suspension on the workpiece surface. Numerical results indicate that ~50% of total particles are impinging the workpiece surface almost perpendicularly (with a mean impact angle of ~86 degrees) for the first time in the stagnation region, where they are strongly decelerated by the carrier fluid before they reach the workpiece surface. These particles, however, rebound on the surface and are reaccelerated by the carrier fluid, impinging the workpiece surface further in the radial direction.

Removing single-point diamond turning marks using form-preserving active fluid jet polishing

Optimization of the Morphology of the Removal Function for Rotating Abrasive Water Jet Polishing

Maskless fluid jet polishing of optical structured surfaces

Research on computer controlled ultra-precision polishing of freeform surfaces

Novel Disc Hydrodynamic Polishing Process and Tool for High-Efficiency Polishing of Ultra-Smooth Surfaces

Surface generation modelling and form maintenance strategy in maskless fluid jet polishing of structured array surface

Numerical and experimental investigation on the material removal profile during polishing of inner surfaces using an abrasive rotating jet

Modeling and analysis for material removal and surface roughness in fluid jet polishing of optical glass

Investigation on form-preserving polishing of side-wall surfaces via an active fluid jet

Modelling of surface morphology and roughness in fluid jet polishing

Micro-milling tool mark removal mechanism by fluid jet polishing and its application for the precision manufacturing of micro-fluidic chip molds

Development of a fluid line-jet polishing process for rotational axisymmetric surfaces

Surface integrity and material removal mechanism in fluid jet polishing of optical glass

Modeling and experimenting of disc hydrodynamic polishing process for ultra-smooth surfaces

Fast-tool-servo-controlled shear-thickening micropolishing

Novel cavitation fluid jet polishing process based on negative pressure effects

The Influence of Impact Angle on Material Removal in Fluid Jet Polishing

Combined Processing Chain for Freeform Optics Based on Atmospheric Pressure Plasma Processing and Bonnet Polishing.

Fundamental research on aspheric surface polishing using doughnut-shaped MCF polishing tool

The Effect Of Process Parameters On Surface Roughness In Abrasive Jet Finishing With Grinding Wheel As Restraint

Towards an Understanding of Multiphase Fluid Dynamics of a Microfluid Jet Polishing Process: A Numerical Analysis