Fluorinated Perylene‐diimides: Cathode Interlayers Facilitating Carrier Collection for High‐Performance Organic Solar Cells
Jia Yao,Shiyu Ding,Rui Zhang,Yang Bai,Qiuju Zhou,Lei Meng,Eduardo Solano,Julian A. Steele,Maarten B. J. Roeffaers,Feng Gao,Zhi‐Guo Zhang,Yongfang Li
DOI: https://doi.org/10.1002/adma.202203690
IF: 29.4
2022-06-22
Advanced Materials
Abstract:Organic solar cells (OSCs) have experienced rapid progress with the innovation of near‐infrared (NIR)‐absorbing small‐molecular acceptors (SMAs), while the unique electronic properties of the SMAs raise new challenges in relation to cathode engineering for effective electron collection. To address this issue, we synthesized two fluorinated perylene‐diimides (PDIs), PDINN‐F and PDINN‐2F by a simple fluorination method, for the application as cathode interlayer (CIL) materials. The two bay‐fluorinated PDI based CILs possess lower the lowest unoccupied molecular orbital energy level of ca. −4.0 eV, which improves the energy level alignment at the NIR‐SMAs (such as BTP‐eC9)/cathode interface for a favorable electron extraction efficiency. The mono‐fluorinated PDINN‐F shows higher electron mobility and better improved interfacial compatibility. The PDINN‐F based OSCs with PM6: BTP‐eC9 as active layer exhibit an enhanced fill factor and larger short‐circuit current density, leading to a high power conversion efficiency (PCE) exceeding 18%. The devices with PDINN‐F CIL retained more than 80% of its initial PCE after operating at the maximum power point under continuous illumination for 750 hours. This work prescribes a facile, cost‐effective and scalable method for the preparation of stable, high‐performance fluorinated CILs, and instilling promise for the NIR‐SMAs‐based OSCs moving forward. This article is protected by copyright. All rights reserved
materials science, multidisciplinary,chemistry, physical,physics, applied, condensed matter,nanoscience & nanotechnology