Abstract:A series of narrow band-gap conjugated copolymers (PFO-DDQ) derived from 9,9-dioctylfluorene (DOF) and 2,3-dimethyl-5,8-dithien-2-yl-quinoxalines (DDQ) is prepared by the palladium-catalyzed Suzuki coupling reaction with the molar feed ratio of DDQ at around 1%, 5%, 15%, 30% and 50%, respectively. The obtained polymers are readily soluble in common organic solvents. The solutions and the thin solid films of the copolymers absorb light from 300–590 nm with two absorbance peaks at around 380 and 490 nm. The intensity of 490 nm peak increases with the increasing DDQ content in the polymers. Efficient energy transfer due to exciton trapping on narrow-band-gap DDQ sites has been observed. The PL emission consists exclusively of DDQ unit emission at around 591–643 nm depending on the DDQ content in solid film. The EL emission peaks are red-shifted from 580 nm for PFO-DDQ1 to 635 nm for PFO-DDQ50. The highest external quantum efficiency achieved with the device configuration ITO/PEDOT/PVK/PFO-DDQ15/Ba/Al is 1.33% with a luminous efficiency 1.54 cd/A. Bulk heterojunction photovoltaic cells fabricated from composite films of PFO-DDQ30 copolymer and [6,6]-phenyl C61 butyric acid methyl ester (PCBM) as electron donor and electron acceptor, respectively in device configuration: ITO/PEDOT:PSS/PFODDQ30: PCBM/PFPNBr/Al shows power conversion efficiencies of 1.18% with open-circuit voltage (V oc) of 0.90 V and short-circuit current density (J sc) of 2.66 mA/cm2 under an AM1.5 solar simulator (100 mW/cm2). The photocurrent response wavelengths of the PVCs based on PFO-DDQ30/PCBM blends covers 300–700 nm. This indicates that these kinds of low band-gap polymers are promising candidates for polymeric solar cells and red light-emitting diodes.

Efficient Red Phosphorescence Polymer Light-Emitting Diodes with Dual Function Polymer

Synthesis and performances of chelating electrophosphorescent polymers based on different ancillary ligands

Utilization of Water/Alcohol-Soluble Polyelectrolyte As an Electron Injection Layer for Fabrication of High-Efficiency Multilayer Saturated Red-Phosphorescence Polymer Light-Emitting Diodes by Solution Processing

Application of Heteroleptic Iridium Complexes with Fluorenyl-Modified 1-Phenylisoquinoline Ligand for High-Efficiency Red Polymer Light-Emitting Devices

High Efficiency All Phosphorescent White Light-Emitting Diodes Based on Conjugated Polymer Host

White polymer phosphorescent light-emitting devices with a new yellow-emitting iridium complex doped into polyfluorene

High-Efficiency Dual-Dopant Polymer Light-Emitting Diodes with Ultrafast Inter-fluorophore Energy Transfer

Efficient Blue Electroluminescence from Neutral Alcohol-Soluble Polyfluorenes with Aluminum Cathode

High-efficiency red-light emission from polyfluorenes grafted with cyclometalated iridium complexes and charge transport moiety.

Efficient, saturated red electroluminescent devices with modified pyran-containing emitters

Highly Efficient and Stable Blue Polymer Light Emitting Diodes Based on Polysilafluorenes with Pendent Hole Transporting Groups

Suppression of Efficiency Roll-off in Highly Efficient Blue Phosphorescent Organic Light-Emitting Devices Using Novel Iridium Phosphors with Good Electron Mobility

Fluorene-carbazole-based hyperbranched polymers with linear red TADF chromophores for high-efficiency white and red electroluminescent devices

Efficient Red Electroluminescent Devices with Sterically Hindered Phosphorescent Platinum(II) Schiff Base Complexes and Iridium Complex Codopant

Red Phosphorescent Organic Light-Emitting Diodes Based on a Novel Host Material with Thermally Activated Delayed Fluorescent Properties

Red Organic Light Emitting Device with Improved Performance Using a Novel Fluorescent Dye Codoped with Phosphor-Sensitizer

Polymer light-emitting devices with phosphorescence and fluorescence dye double-doped polymer as emitting layer

FLUORENE-BASED COPOLYMERS FOR RED LIGHT-EMITTING DIODES AND BULK HETEROJUNCTION PHOTOVOLTAIC CELL

Synthesis and Electroluminescent Properties of a Phenothiazine‐based Polymer for Nondoped Polymer Light‐emitting Diodes with a Stable Orange‐red Emission

P‐168: Investigation of High‐Efficiency Electrophosphorescent Organic Light‐emitting Diodes with Double‐Emission Layers

High performances red phosphorescent organic light-emitting diodes with low operation voltage