Abstract:Hot dip galvanized products are widely used in various aspects of production and life due to their excellent corrosion resistance. Some studies have added a fourth trace alloying element to the zinc aluminum magnesium coating to form a quaternary alloy for better performance. This article prepared two different types of Zn−Al−Mg alloy ingots with trace amounts of Si added by induction melting, consisting of Zn1Al1Mg0.01Si and Zn1Al1Mg0.05Si, and solidified them in a heating furnace with argon gas protection atmosphere. The precipitation process of Zn1Al1Mg(0.01,0.05)Si alloy components under non equilibrium and equilibrium solidification conditions was calculated. The initial crystalline phase of the alloy and the initial solidification temperature were predicted through phase diagram calculations. The microstructure and phase types of the alloy were analyzed using scanning electron microscopy (SEM) and field emission scanning electron microscopy (FE-SEM). The electrochemical Tafel curves of Zn1Al1Mg(0.01,0.05)Si with different Si contents showed that the Zn1Al1Mg0.05Si has the highest corrosion potential and Zn1Al1Mg0.01Si has the lowest corrosion current which means the 1Al1Mg0.01Si alloy possesses the highest corrosion resistance. The Nyqust curves and bode curves also showed that the practical impedance of 1Al1Mg0.01Si alloy is higher than that of 1Al1Mg0.05Si. Moreover, electron probe X-ray micro-analyzer(EPMA) reveals the distribution of Si elements in the Zn1Al1Mg(0.01,0.05)Si. At present, there is little research on the microstructure and properties of quaternary alloys containing silicon. Therefore, studying the influence of silicon content on the microstructure and properties of alloys is of great significance.

The Study of Ferrosilicon Alloy Sediment Horizon Metallographic Etchant

Microstructure Analysis on Materials of Electroslag Strip Welding(esw) with Austenitic Stainless Steel

Studies On Synthesis Mechanism Of Fe-Si Alloy

Preparation Method for Metallographic Specimen of Iron-Carbon and Silicon-aluminium Alloy

The Choice of Metallographic Corrosive in the Sample of Electro-Deposition Silicon Steel Section

Study on Metallographic Techniques for Cast Mg Alloy

The Effect of Electro-Deposition Time to the Microstructure and the Texture of Silicon Steel

Electro-deposition method's influence to ferrosilicon organization

Optimizing Metallographic Etchants for Ancient Gold and Silver Materials

Novel Method for Studying the Complex Microstructure of a Sm(Co/Fe/Cu/Zr)7.3 Permanent Magnet Alloy

Metallographic etching of Al‐Mg‐Zn‐(Cu) crossover alloys

Preliminary study on smelting micro-carbon ferromanganese alloy by electro silicon thermal one-step process

Electromagnetic levitation and solidification of ferrosilicon alloy and resulting microstructural evolution mechanisms

Process Optimization and Structural Characterization of Fe3Si Layer by Pulse Electrodeposition

Optimization of Metal-Assisted Etchant Components for Fabrication of Porous Silicon

Solidification structure development of silicon steel prepared by near-rapid solidification

Mechanism of Etching of Al-4.5Mg-1.0Mn Alloy

Metallographic Etch for Cast AZ91D Magnesium Alloy

Microstructure and Corrosion Resistance of Solidified Zn-Al-Mg Alloys

Electron Microanalysis of White Sediments in the Inner Wall of Horizontal Annealing Furnace

Microstructure heritance of metallographic feature in the anodization of carbon steels