Abstract:Abstract The field under study is located in the northern part of Oman where most of the fields have a tight carbonate oil reservoirs. Initially the field was produced under natural depletion for almost 15 years until 2005 when a line drive water flood development with horizontal wells took place and was deployed in the whole field. After more than 10 years of water injection, the water cut reached an average of 75% in the major producing blocks. The reservoir has a light oil with viscosity of 0.8 mPa.s, a downhole temperature of 87°C and average permeability of 10 mD. The calcium and magnesium concentration in formation water is high, about 4000 mg/L. Reservoir heterogeneity in tight carbonate reservoirs causes uneven water flood sweep efficiency and hence resulted in a lot of bypassed oil. The initial EOR methods screening in the field under study didn't recommend to use the conventional polymer flooding due to low reservoir permeability and hence injectivity challenge. However, a new unique nano-ploymer was recently developed in the market to be a potential EOR method for such tight formation reservoirs. Extensive laboratory experiments using the core and fluid samples from the studied reservoir followed by numerical simulation modeling work proved the technical feasibility for this new polymer. This was then followed by field testing pilot in one of the matured water flood sector and the performance is currently under monitoring. The new polymer is a particle-type and comes with various nanometer-micrometer sizes. This polymer has a low apparent viscosity of 1-4 mPa and when it is mixed with the injection water, the particles disperse in the water and the resultant mixture has a low viscosity making it easily to be injected. In addition, this nano-polymer has a high tolerance for both temperature and salinity. While the particles move into formation, they temporarily plug the preferential existing water paths and divert the injection water into the relatively small pores/throats and displace the remaining bypassed oil. The polymer particle has high deformation capacity, so it can deform and pass through the throat under certain pressure to plug even deeper parts of the formation. The process is repeated continuously so that it can inhibit water production and enhance oil production. For the lab experiments, 12 core plugs from the associated reservoir were collected, based on which, a series of experiments were conducted including: core thin section analysis, injectivity test for the nano-polymer and core flooding experiments on single plug and parallel double plugs. Subsequently, the lab results were utilized for numerical simulation and that was followed by economic evaluation. Based on the lab test results, a conceptual simulation model for the studiedfield's sector was used to estimate the incremental oil gain at different pore volume (PV) injection. The incremental oil gain was determined at different SMG PV injection starting from 0.05PV to 0.5 PV. The results showed that the best economic scenario is to go for PV injection of 0.3 which can be achieved in ~4 years'time. However, in order to expedite the field trail stage and reduce its cost, the lowest PV injection was selected which involves injection in two water injectors for one year only at 0.05 PV. The field pilot thus far has successfully completed the injection phase of the total planned volume (0.05 PV) of nano-ploymer. The injection was continuous for one year with no injectivity issue and the production performance is currently under monitoring.

Combined Oil Displacment System and Field Test of Composite Surfactant

Combined oil displacement system and field test of rhamnolipid

Construction and performance evaluation of novel compound oil displacement system for enhanced oil recovery

A Laboratory Experimental Study on Enhancing the Oil Recovery Mechanisms of Polymeric Surfactants

The research and application of compound flooding system in the block L of Huabei oilfield

Dissipative Particle Dynamics Simulation and Microscopic Experimental Study of Emulsification Performance of Surfactant/Polymer Flooding

EOR mechanism of fracture oil displacement agent for ultra-low permeability reservoir

Improved Oil Recovery by Chemical Flood from High Salinity Reservoirs-Single-Well Surfactant Injection Test

Spontaneous emulsification induced by a novel surfactant-polymer compound system and its application to enhance oil recovery

Research on Characterization Technology and Field Test of Biological Nano-oil Displacement in Offshore Medium- and Low-Permeability Reservoirs

Water Shutoff and Conformance Improvement for Lamadian Oilfield in Daqing Using a Novel Polymer System: Experimental Study, Simulation, and Pilot Tests

Synergistic anionic/zwitterionic mixed surfactant system with high emulsification efficiency for enhanced oil recovery in low permeability reservoirs

Experimental study of nanoparticle and surfactant stabilized emulsion flooding to enhance heavy oil recovery

Zwitterionic-nonionic compound surfactant system with low chromatographic separation effect for enhanced oil recovery

Study on Surfactant–Polymer Flooding after Polymer Flooding in High-Permeability Heterogeneous Offshore Oilfields: A Case Study of Bohai S Oilfield

A New Polymer Flooding Technology for Improving Low Permeability Carbonate Reservoir Recovery--From Lab Study to Pilot Test--Case Study from Oman

Development and Application of Efficient Oil Displacement System for Middle-Low Permeability and High Pour-Point Heavy Oil Reservoirs

Quantitative Characterization of Surfactant Displacement Efficiency by NMR—Take the Tight Oil of Chang 8 Member of Yanchang Formation in Fuxian Area, Ordos Basin, as an Example

Study on the influence of emulsification ability of oil displacement system on its chemical flooding recovery

A review of surfactants as synergists in the field of enhanced oil recovery

Study on Viscosity Reducer Flooding Technology for Deep Low Permeability Extra Heavy Oil Reservoirs