Improved Oil Recovery by Chemical Flood from High Salinity Reservoirs-Single-Well Surfactant Injection Test

ben shiau,mahesh budhathoki,xiaoguang wang,zhixun lin,wei wan,bruce l roberts,prapas lohateeraparp,jeffrey h harwell,tzuping hsu

DOI: https://doi.org/10.2118/154838-ms

2012-01-01

Abstract:Abstract Reservoirs containing very high total dissolved solids and high hardness make the design of a surfactant polymer (SP) flood extremely difficult because surfactant tends to precipitate and separate under these conditions. Beside divalent ions, Ca2+and Mg2+, the presence of iron in the brine can be a challenging issue. Different surfactant formulations incorporating cosurfactants and co-solvents are studied. These formulations minimize viscous macroemulsions, promote rapid coalescence under Winsor Type III conditions, and stabilize the chemical solution by reducing precipitation and phase separation. The optimal surfactant formulations are further studied in one-dimensional sand packs and coreflood tests using Berea sandstone, reservoir oils, and brines at 42°C. Using similar injection protocols, 0.5 PVs surfactant/polymer, oil recoveries ranging from 50 % to 70% of the residual oil (Sor) after waterflooding are observed. The level of surfactant loading is less than 0.6 wt%. A single-well test is conducted to confirm laboratory results in situ in the presence of high-salinity formation water containing 165,000 mg/L total dissolved solids (TDS). The test is considered to be a technical success and confirms the effectiveness of a high-salinity surfactant-polymer formulation composed of 0.23 wt% of surfactant and 1,800 ppm of polymer loading. Approximately 87% of the residual oil was mobilized.