Abstract:The paper describes physical and numerical simulations of a manufacturing process composed of hot forging and controlled cooling, which replace the conventional heat treatment technology. The objective was to investigate possibilities and limitations of the heat treatment with the use of the heat of forging. Three steels used to manufacture automotive parts were investigated. Experiments were composed of two sets of tests. The first were isothermal (TTT) and constant cooling rate (CCT) dilatometric tests, which supplied data for the identification of the numerical phase transformation model. The second was a physical simulation of the sequence forging-cooling on Gleeble 3800, which supplied data for the validation of the models. In the numerical part, a finite element (FE) thermal-mechanical code was combined with metallurgical models describing recrystallization and grain growth during forging and phase transformations during cooling. The FE model predicted distributions of the temperature and the austenite grain size in the forging, which were input data for further simulations of phase transformations during cooling. A modified JMAK equation was used to calculate the kinetics of transformation and volume fraction of microstructural constituents after cooling. Since the dilatometric tests were performed for various austenitization temperatures before cooling, it was possible to include austenite grain size as a variable in the model. An inverse algorithm developed by the authors was applied in the identification procedure. The model with optimal material parameters was used for simulations of hot forging and controlled cooling in one of the forging shops in Poland. Distributions of microstructural constituents in the forging after cooling were calculated. As a consequence, various cooling sequences during heat treatment could be analyzed and compared.

A Single Stage Hot Forging Process of Alternator Poles

A Single Stage Hot Forging Process and Die Set of Alternator Poles

Study on Forming Process of Two Closed Die Forging Steps in One Time Heating for Alternator Poles

Research on Combined Hot Extrusion Forming Process of Alternator Poles

Precision Forging of Alternator Poles by Flow Control Method

A Combined Radial Forging-Forward Extrusion Forming Process of Alternator Poles

Study on Warm and Cold Precision Forming Process of Automobile Alternator Claw Poles

Research situation and development tendency of forming technology for automotive alternator poles

Hot trimming technology of alternator pole

Experimental Study on Process of Precision Forging of an Aluminium-Alloy Rotor

Process Design Based on Fe Simulations and Experiments of Forging A Complex-Shaped Magnesium Alloy Adaptor

Experimental Study and Numerical Simulation of Isothermal Closed Die Forging for Aluminium Alloy Rotor

Hot Precision Forging Process and Experiment Research of Driven Spiral Bevel Gear

Technological simulation of the process of hot forging of two-layer forgings with deep cavities and an inverted cone

Numerical Simulation Research on Final Forging Process of 700MW Class Heavy Hydro-generator Shaft

Research and Application of Precision Forging Forming Process for Flat Thin Flash of Automobile Disc Steering Knuckle

Physical and Numerical Simulations of Closed Die Hot Forging and Heat Treatment of Forged Parts

STUDY ON THE NUMERICAL SIMULATION OF MULTI-STAGE ROTARY FORGING OF A NON-AXISYMMETRIC PART AND THE CAE ANALYSIS OF THE DIE STRENGTH

Modeling research on FM forging process of heavy low-pressure turbine rotor

Numerical simulation and experiment study on hot extrusion process of 18Ni (250) maraging steel large fan shaft for aero-engines

Hot forging process design and parameters determination of magnesium alloy AZ31B spur bevel gear