Abstract:Claw poles are a key component of automobile generators. The output power performance of the generator is very dependent on the magnetic properties of its claw poles. Plastic deformation is known to significantly change the magnetic behavior of ferromagnetic materials in claw poles. In this paper, changes in the magnetic properties of low-carbon steel, used for claw pole components due to their plastic deformation, were investigated for different strains and temperatures. Ring-shaped material samples were prepared by machining and their magnetic properties were measured. The surface roughness was first evaluated and a machining process with an arithmetic average of roughness Ra 1.6 µm was selected as enabling the lowest measurement error. Hysteresis loops at different applied magnetic fields of the material were obtained for different plastic strains and forming temperatures. The magnetic parameters of magnetic flux density, coercivity, and remanence were obtained and compared with magnetic flux density as the primary focus. Results showed that machining, cold forming, and hot forming all led to lower magnetic flux density, larger coercivity, and smaller remanence. Magnetic flux density showed a sharp decrease at the start of plastic deformation, but as the strain increased, the decreasing trend gradually reached a constant value. The decrease was much larger for cold forming than for hot forming. For example, at 500 A/m, the degradation of magnetic flux density with a reduction percentage of 5% at room temperature was about 50%, while that of hot forming at 1200°C was about 10%. Results of this research may provide a reference for the future process design of hot-forged claw poles.

Research situation and development tendency of forming technology for automotive alternator poles

Research on Combined Hot Extrusion Forming Process of Alternator Poles

Study on Forming Process of Two Closed Die Forging Steps in One Time Heating for Alternator Poles

Study on Warm and Cold Precision Forming Process of Automobile Alternator Claw Poles

Study on Simulation of Stamping Forming and Die Surface Optimization of Aluminum Alloy Plate

A Single Stage Hot Forging Process of Alternator Poles

A Single Stage Hot Forging Process and Die Set of Alternator Poles

A Combined Radial Forging-Forward Extrusion Forming Process of Alternator Poles

Precision Forging of Alternator Poles by Flow Control Method

Hot trimming technology of alternator pole

Effect of Plastic Strain and Forming Temperature on Magnetic Properties of Low-Carbon Steel

Hot forming technology of automotive high strength steel sheet stamping part

Improving the Quality of Hot Stamping Parts with Innovative Press Technology and Inline Process Control

Development Tendency of Materials Processing Techniques Facing Automobile Lightening Design

New development of powder metallurgy in automotive industry

Suitable Claw Shape Design for Improving the Magnetic Properties of Forged Claw Pole Parts in Generator

Research and Application of Precision Forging Forming Process for Flat Thin Flash of Automobile Disc Steering Knuckle

Heat treatment-stamping integrated techniques for aluminum alloy sheets in the automotive body manufacture

Research Status and Development Trends of Prediction Technology for Precision Forming Parts' Accuracy

Research on precise plastic forming technology of rotors with twist radial blades

Cold forging of high strength aluminum alloys and the development of new thermomechanical processing