Abstract:This paper presents microfabrication process-driven design of a multi-degree of freedom (multi-DoF) non-resonant electrostatic microelectromechanical systems (MEMS) gyroscope by considering the design constraints of commercially available low-cost and widely-used silicon-on-insulator multi-user MEMS processes (SOIMUMPs), with silicon as a structural material. The proposed design consists of a 3-DoF drive mode oscillator with the concept of addition of a collider mass which transmits energy from the drive mass to the passive sense mass. In the sense direction, 2-DoF sense mode oscillator is used to achieve dynamically-amplified displacement in the sense mass. A detailed analytical model for the dynamic response of MEMS gyroscope is presented and performance characteristics are validated through finite element method (FEM)-based simulations. The effect of operating air pressure and temperature variations on the air damping and resulting dynamic response is analyzed. The thermal stability of the design and corresponding effect on the mechanical and capacitive sensitivity, for an operating temperature range of −40 °C to 100 °C, is presented. The results showed that the proposed design is thermally stable, robust to environmental variations, and process tolerances with a wide operational bandwidth and high sensitivity. Moreover, a system-level model of the proposed gyroscope and its integration with the sensor electronics is presented to estimate the voltage sensitivity under the constraints of the readout electronic circuit.

A Theoretical and Experimental Study on Temperature Dependent Characteristics of Silicon MEMS Gyroscope Drive Mode

A Research on Temperature Dependent Characteristics of Quality Factor of Silicon MEMS Gyroscope

Temperature-dependence improvement for a MEMS gyroscope using triangular-electrode based capacitive detection method

Design of Temperature Control System of Pico-Satellite MEMS Gyroscope

The Analysis of Temperature Effect and Temperature Compensation of Moems Accelerometer Based on A Grating Interferometric Cavity

Temperature Compensation Method for MEMS Accelerometer Based on Resonant Frequency

Research on temperature dependent characteristics and compensation methods for digital gyroscope

A Sub-0.1°/H Bias-Instability MEMS Gyroscope Using Resonant Constant-Frequency Driving Technique

Effects of Structural Dimension Variation on the Vibration of MEMS Ring-Based Gyroscopes

A 0.09°/h Bias-Instability MEMS Gyroscope Working with a Fixed Resonance Frequency

Research on Thermal Characteristic and Compensation Algorithm for MEMS-gyroscope

MEMS Gyroscope Temperature Compensation Based on Drive Mode Vibration Characteristic Control

Research on Low Temperature Drift Suppression of Micro-Machined Gyroscope Based on Self-Calibration Technology

STUDY ON DYNAMIC CHARACTERISTIC OF A NOVEL SILICON MICROMACHINED GYROSCOPE

A Temperature Drift Suppression Method of Mode-Matched MEMS Gyroscope Based on a Combination of Mode Reversal and Multiple Regression

Microfabrication Process-Driven Design, FEM Analysis and System Modeling of 3-DoF Drive Mode and 2-DoF Sense Mode Thermally Stable Non-Resonant MEMS Gyroscope

Temperature insensitive design of MEMS resonant accelerometer

Bias Thermal Stability Improvement of MEMS Gyroscope with Quadrature Motion Correction and Temperature Self‐sensing Compensation

An In-Run Automatic Demodulation Phase Error Compensation Method for MEMS Gyroscope in Full Temperature Range

Study Of A Novel Silicon Micromachined Gyroscope

An 8PPM/°C Temperature Sensitivity of the Scale Factor in MEMS Gyroscope Based on Multi Parameters Fusion Compensation Method