Abstract:The study of single grit grinding with different geometries is important for understanding the micro-cutting behavior and material removal mechanism during grinding. However, the geometry of the grit changes during the wear process. The most fatal wear form responsible for the change in geometry is grit fracture as it causes considerable material loss instantaneously. This paper presents a new method to simulate single grit grinding with the fracture wear effects incorporated. The simulation procedure consists of three phases. The grinding force is calculated in phase 1, the grit fracture wear is simulated in phase 2, and the geometry of the grit after fracture wear is updated in phase 3. The evolution of grit fracture and its impact on cutting performance are studied by recycling the simulation procedure until the grit wears out. The results obtained reveal that the fracture wear is primarily caused by the maximum tensile stress along the rake surface or inside the grit. The resultant grinding force fluctuates during the chip formation process and is controlled by the number of cutting edges and the effective area of the flank surface. It decreases rapidly at the initial wear stage and varies with the dulling and self-sharpening action induced by the fracture wear. The volume of grinding chip decreases with an increase in the number of micro-cutting edges, which may result from a decrease in the ploughing effect.

A Study on Grinding Rate of Mica Particles

Influence of ball size distribution on grinding effect in horizontal planetary ball mill

Investigation of the Ball Wear in a Planetary Mill by DEM Simulation

Experimental Research on the Effect of Grinding Parameters on Ceramic Machined Surface Roughness

Numerical Investigation of the Evolution of Grit Fracture and Its Impact on Cutting Performance in Single Grit Grinding

Grinding kinetics of coal in wet ball-milling using the Taguchi method

A study of the grinding of magnetite/limestone mixture in a stirred mill by the attainable region method

Study on Energy Transfer Mechanism of Grinding Balls in a Planetary Ball Milling System

Effect of Grinding Media Proportion on Breakage Efficiency of Clinker in a Planetary Mill

Correlation of Size Reduction Rate of Inorganic Materials with Impact Energy of Balls in Planetary Ball Milling

Particle Impact Energy Variation with the Size and Number of Particles in a Planetary Ball Mill

Effect of Grinding Media Size on Grinding Kinetics of Cement Clinker in Ball Mill

Dry grinding in planetary ball mills: Evaluation of a stressing model

Dry Grinding Effect on Pyrophyllite-Quartz Natural Mixture and Its Influence on the Structural Alternation of Pyrophyllite.

Effect of Grinding Media Shape on Breakage Parameters of Cement Clinkers

The Mechanism and Grinding Limit of Planetary Ball Millingt

Optimum revolution and rotational directions and their speeds in planetary ball milling

Modelling of dry milling in planetary ball mill through discrete element method

Investigating the Influence of Medium Size and Ratio on Grinding Characteristics

Evaluation of particle size reduction and agglomeration in dry grinding of natural quartz in a planetary ball mill

Effect of feed size on residence time and energy consumption in a stirred mill: An attainable region method