Abstract:The planetary mill is one of the most commonly used mills for ultrafine grinding in the laboratory, given its ability to reach higher intensity of the collisions as the result of increase in rotational frequency and ball acceleration without the undesired centrifugation of the grinding charge. Several attempts have been made in the literature to develop a predictive model of this mill, with limited success. The work applies the mechanistic UFRJ mill modeling approach to predict the size distribution in a laboratory planetary mill, on the basis of single-particle slow compression data obtained using a micro compression tester, besides simulations using the discrete element method. At first, careful verification of the Hertz-Mindlin contact parameters was conducted using a video recording system that moves along with the jar during milling. Grinding tests were conducted with hematite for the mill operating at frequencies that varied from 150 to 300 rpm, resulting in generally very good agreement between model and experiments. However, agreement between the two was found to reduce for the highest rotational frequency studied. This was attributed to the reduction in grinding efficiency in the experiments that was not observed in the simulations, which resulted in predicted values overestimating fineness of the product. Finally, simulations were compared to experiments for quartz, silicon carbide and blast furnace slag under identical conditions and it was shown that the model provided very good predictions, with the exception of quartz.

The Mechanism and Grinding Limit of Planetary Ball Millingt

Investigation of the Ball Wear in a Planetary Mill by DEM Simulation

Study on Energy Transfer Mechanism of Grinding Balls in a Planetary Ball Milling System

Experimental Study and Numerical Simulation of the Influence of Ball Milling on Mechanical and Physical Properties of Matcha Powder

Influence of ball size distribution on grinding effect in horizontal planetary ball mill

Model Study of Mechanicochemical Degradation in a Planetary Ball Mill

Influence of processing parameters on grinding mechanism in planetary mill by employing discrete element method

Theoretical Generalization and Research on the Mechanism of the Unsteady-State Grinding Technique

Studying on the Upper Limit of the Coarse-Grained DEM Model for Simulating Mixing Processes in a Rolling Drum with Complex Wall Boundary

Mechanistic modeling and simulation of a wet planetary ball mill

A mathematical analysis of milling mechanics in a planetary ball mill

The Working Principle of Dual-Planetary Ball Mill and the Establishment of the Discrete Element Mode

Scale-up method of planetary ball mill

Simulation of ball motion and energy transfer in a planetary ball mill

Correlation of Size Reduction Rate of Inorganic Materials with Impact Energy of Balls in Planetary Ball Milling

Application of discrete element simulation in mechanical activation of boron concentrate

Trajectories and impact velocities of grinding bodies in planetary ball mills

Particle Impact Energy Variation with the Size and Number of Particles in a Planetary Ball Mill

Particle aggregation and the grinding limit in high energy ball mill

Powder Ball Milling: An energy balance approach to particle size reduction

Dry grinding in planetary ball mills: Evaluation of a stressing model