Abstract:The planetary mill is one of the most commonly used mills for ultrafine grinding in the laboratory, given its ability to reach higher intensity of the collisions as the result of increase in rotational frequency and ball acceleration without the undesired centrifugation of the grinding charge. Several attempts have been made in the literature to develop a predictive model of this mill, with limited success. The work applies the mechanistic UFRJ mill modeling approach to predict the size distribution in a laboratory planetary mill, on the basis of single-particle slow compression data obtained using a micro compression tester, besides simulations using the discrete element method. At first, careful verification of the Hertz-Mindlin contact parameters was conducted using a video recording system that moves along with the jar during milling. Grinding tests were conducted with hematite for the mill operating at frequencies that varied from 150 to 300 rpm, resulting in generally very good agreement between model and experiments. However, agreement between the two was found to reduce for the highest rotational frequency studied. This was attributed to the reduction in grinding efficiency in the experiments that was not observed in the simulations, which resulted in predicted values overestimating fineness of the product. Finally, simulations were compared to experiments for quartz, silicon carbide and blast furnace slag under identical conditions and it was shown that the model provided very good predictions, with the exception of quartz.

The Working Principle of Dual-Planetary Ball Mill and the Establishment of the Discrete Element Mode

Investigation of the Ball Wear in a Planetary Mill by DEM Simulation

Experimental Study and Numerical Simulation of the Influence of Ball Milling on Mechanical and Physical Properties of Matcha Powder

Dynamics Analysis of Spatial Mechanisms with Dry Spherical Joints with Clearance Using Finite Particle Method

Study on Energy Transfer Mechanism of Grinding Balls in a Planetary Ball Milling System

Mechanistic modeling and simulation of a wet planetary ball mill

Discrete Element Method Simulation of Filling Level in Planetary Ball Mill

Simulation of ball motion and energy transfer in a planetary ball mill

Modelling of dry milling in planetary ball mill through discrete element method

Processing of Wc-Co Cemented Carbide Balls by Rotated Dual-Plates Lapping Machine

Discrete element modeling and simulation of non-spherical particles using polyhedrons and super-ellipsoids

Dem Investigation Of Sag Mill With Spherical Grinding Media And Non-Spherical Ore Based On Polyhedron-Sphere Contact Model

Model Study of Mechanicochemical Degradation in a Planetary Ball Mill

Simulations of Planetary Ball Mill Using Discrete Element Method Modeling

The Mechanism and Grinding Limit of Planetary Ball Millingt

A mathematical analysis of milling mechanics in a planetary ball mill

DEM Modeling and Optimization of the High Energy Ball Milling

Numerical Investigation of a Vertical Roller Mill Using DEM-MBD Coupling Method

Simulation of a Laboratory Scale Ball Mill via Discrete Element Method Modelling

Scale-up method of planetary ball mill

Research on An Accurate Simulation Modeling and Charge Motion Quantitative Evaluation Method for Ball Mill in Confined Space