Abstract:In the present study, the effect of not so much discussed milling parameters such as vial to plate spinning rate, ball size distribution and type of balls on the performance (energy) of the high energy ball milling has been investigated for the first time. Furthermore, different scenarios that lead to an increase in the BPR such as the powder weight loss, the increase of diameter and the number of balls are analyzed and their effects on the efficiency of the milling are discussed. The important point is that contrary to the previous studies in which the milling parameters were independently investigated, in this research the effects of the milling parameters on the performance of the mill are simultaneously investigated. The results showed that the powder weight loss can greatly enhance the performance of milling, while the increase of the number of balls at high BPR ratio, has a quite negative effect on the milling performance. Besides, excessive rise in the ball size distribution is associated with adverse outcomes in the milling efficiency, especially when the number of balls increases. Furthermore, the balls made of tungsten carbide compared to those of silicon nitride and steel have a more positive effect on the milling efficiency especially when the weight of powder is reduced. A mathematical model is also introduced to analyze the effect of milling parameters on the milling energy and the obtained results are compared with the experimental ones. According to the results obtained, if the vial to plate spinning rate is 1.2, the mill has a better performance however, by increasing the diameter of the balls, this ratio is changed to 1.4.

Experimental Study and Numerical Simulation of the Influence of Ball Milling on Mechanical and Physical Properties of Matcha Powder

Investigation of the Ball Wear in a Planetary Mill by DEM Simulation

Study on Energy Transfer Mechanism of Grinding Balls in a Planetary Ball Milling System

Comprehensive Study of Matcha Foam Formation: Physicochemical Composition Analysis and Mechanisms Impacting Foaming Properties

Discrete Element Method Simulation of Filling Level in Planetary Ball Mill

Numerical Investigation of a Vertical Roller Mill Using DEM-MBD Coupling Method

Influence of processing parameters on grinding mechanism in planetary mill by employing discrete element method

Dem Investigation Of Sag Mill With Spherical Grinding Media And Non-Spherical Ore Based On Polyhedron-Sphere Contact Model

Model Study of Mechanicochemical Degradation in a Planetary Ball Mill

Mechanical milling and its influence on microstructure and electric conductivity of high mass fraction TiC / Cu composites

Simulations of Planetary Ball Mill Using Discrete Element Method Modeling

Optimization of the high energy ball-milling: Modeling and parametric study

Discrete element modeling and simulation of non-spherical particles using polyhedrons and super-ellipsoids

Research on An Accurate Simulation Modeling and Charge Motion Quantitative Evaluation Method for Ball Mill in Confined Space

Investigation of the Effect of Filling Level on the Wear and Vibration of a SAG Mill by DEM

The Influence of Ball Milling Conditions on the Powder Characteristics and Sintering Densification of Mo-Cu Alloy

Modification on the Performance of the Hemihydrate Gypsum with the Plant Source Polymer of Dry Matcha Powder

Effect of ball-milling parameters on the rheological properties of mold powder slurry

Simulation of ball motion and energy transfer in a planetary ball mill

Effect of Different Milling Media for Surface Coating on the Copper Powder Using Two Kinds of Ball Mills with Discrete Element Method Simulation