Abstract:The behavior of cross-laminated timber (CLT) and reinforced concrete (RC) floors in a multi-story building is investigated in this paper. The load-bearing capacity, fire resistance, and sound insulation characteristics of the floors are the main focus of this research. In order to achieve this goal, a four-story building having RC floors is modeled, analyzed, and designed using the StruSoft FEM-Design software (FEM) following the Eurocodes and Swedish national annex. The building is considered to be in the city of Gävle in Sweden. Then, the RC floors of the building are replaced with the CLT floors, and the same process is done utilizing FEM. The utilization ratios (the ratios of the applied loads to the load-bearing capacities), vertical deflections, weights of the RC and CLT floors, and reaction forces of the buildings are evaluated and compared. The results show that the RC floors meet the deflection requirements well which contributes to the focus on their utilization ratios. The designed RC floors are acceptable from the vertical deflection and utilization ratio perspectives. However, the CLT floors cannot meet the vertical deflection requirements, and thus, need strengthening. The CLT floors are strengthened with supporting timber beams and columns which result in acceptable vertical deflections and utilization ratios. Fire resistance and sound insulation conditions of the RC and CLT floors are assessed by calculations based on the requirements of the Swedish National Board of Housing, Building, and Planning regulations (BBR) as well. The RC floors have the ability to be soundproof and have no difficulties in meeting the fire resistance requirements R60 of BBR. A cross-section is proposed for the CLT floors which can meet the fire resistance requirement R60 and sound insulation requirement C of BBR. The maximum reaction forces of the buildings and total weights of the floors are larger in the case of RC than CLT.

The Study on Light Floor Impact Sound Improvement by Void Slab Applied with Surface Covering Materials

Acoustic Properties of Glued Laminated Bamboo and Spruce-Pine-fir

Strengthening Slab Stiffness to Reduce Heavy-weight Impact Noise on the Floor

Housing Design Should Pay High Attention to Sound Insulation for Floor Slab

Sound insulation performance of different built-in acoustic materials for new multifamily residential

Effects of Periodic Materials on Distance Attenuation in Wall–Slab Structures: An Experiment

The Influence of Floor Layering on Airborne Sound Insulation and Impact Noise Reduction: A Study on Cross Laminated Timber (CLT) Structures

Finite element simulation and falling ball impact model for cement concrete pavement considering void under slab

Study on Natural Frequency of Concrete Floor Based on Vibration Serviceability

Effects of impact and microphone positions on heavy-weight floor impact sound pressure levels in concrete buildings

Numerical Investigation on the Natural Frequency of RC Slab Reinforced with Cambered Steel Beam for Reducing Heavy-Weight Impact Noise

Light–weight Impact Sound Evaluation of CLT Wooden Building Floors

Acoustic Retrofit Approach of an Apartment Living Room Using Multi-Perforated Gypsum Boards in Terms of Heavy-Weight Impact Sounds

The Transmission Characteristics and Influence Prediction of Impulsive Vibration Caused by a Solid Metal Ball Impact in Buildings

The effect of damping materials on heavy‐weight floor impact in apartment buildings

Reduction in Floor Impact Noise Using Resilient Pads Composed of Machining Scraps

The behavior of cross-laminated timber and reinforced concrete floors in a multi-story building

Environmental Impact of Acoustic Materials in Residential Buildings

Sound Insulation Performance of Foam Rubber Damping Pad and Polyurethane Foam Board in Floating Floors

Structural and acoustic behavior of a timber slab with wooden tuned mass dampers

Spatial Design Strategies for Lightweight Roofing Buildings Driven by Rain Noise Reduction