Abstract:The Euler–Lagrange method is a great way for multiphase bubble flow simulation, the detailed information of bubbles can be effortlessly obtained, and it is helpful for the efficiency and safety of different industry processes. Traditionally, the computational fluid dynamics-discrete bubble model (CFD-DBM) method has always been used to simulate this flow process. Nevertheless, the ability of the traditional CFD-DBM method is significantly limited in terms of the size ratio between the grid and bubble, where the grid size must be larger than the bubble size. In reality, the bubble may be larger than the grid and the grid/bubble size ratio can be very large due to the effects of complex bubble dynamics (such as the bubble breakup and coalescence) and complex internal flows. To address this issue, an improved CFD-DBM method is proposed in this study, which can be used for the simulation with a wide grid/bubble size ratio in gas–liquid–bubble multiphase simulation, and the volume of fluid (VOF) method is applied to capture the interface between gas and liquid phases. A gradient-based interpolation method is employed to reconstruct the liquid velocity around the target bubble when the grid size is much larger than the bubble size. If the bubble size is comparable with or larger than the grid size, the interphase force correction and the field smoothing will be carried out within a spherical support area. Subsequently, the proposed model is validated by the comparison with a bubble column experiment, in terms of the bubble size distribution and bubble vertical velocity. The results demonstrate the high accuracy of the new method. Finally, the influence of different parameters including normal spring stiffness, critical Weber number, and the range of the spherical support area on the bubble flow is investigated.

Cfd Simulations and Piv Measurements for Optimization of Flow Pattern in A Sieve Plate Extraction Column

Flow Pattern Optimization of a Sieve Plate Extraction Column Using Computational Fluid Dynamics Simulations and Particle Image Velocimetry Measurements

Cfd Simulations of Flow Characteristics in Pulsed-Sieve-Plate Extraction Columns

Sidestream Analysis and Optimization of Full Tower Internal Thermally Coupled Air Separation Columns

CFD Simulation of Two-Phase Flow in a Hybrid Pulsed Sieve-Plate Solvent Extraction Column: Prediction of Holdup and Axial-dispersion Coefficients

High-efficient CFD-based framework for the comprehensive hydrodynamic evaluation of pulsed extraction columns

CFD study on liquid flow behavior on inclined flat plate focusing on effect of flow rate

An Improved Computational Fluid Dynamics-Discrete Bubble Model for Multiphase Bubble Flow Simulation with a Wide Grid/bubble Size Ratio

CFD-PBM Simulation of Sauter Mean Diameter in a Stirred Sieve-Plate Extraction Column

CFD Simulation of Flow and Mass Transfer in Structured Packing Distillation Columns

FEM Simulation and Optimization Design of Flow Field in CVI Reactor

Progress of Simulation of Fluid Flow Behavior in Structured Packed Column by Computational Fluid Dynamics

Portraying the Countercurrent Flow on Packings by Three‐Dimensional Computational Fluid Dynamics Simulations

CFD study on flow characteristics of sieve tray columns with circular downcomers

CFD Simulation of Liquid–Liquid Two-Phase Hydrodynamics and Axial Dispersion Analysis for a Non-Pulsed Disc and Doughnut Solvent Extraction Column

A Novel Cross-Flow Cascade Packed Column Design and Simulation

NUMERICAL SIMULATION AND OPTIMIZATION OF GAS-SOLID TWO-PHASE FLOW IN ONE CFBC CYCLONE SEPARATOR

Mass transfer and axial mixing characteristics in a coalescence-dispersion pulsed-sieve-plate extraction column

CFD Simulation of the Flow Patterns and Structure Optimization Within a Continued-Flow Integrated Biological Reactor

An Experimental and Numerical Investigation of Flow Patterns in the Entrance of Plate-Fin Heat Exchanger

Detached Eddy Simulation and PIV Validation of the Flow in a Compact Return Diffuser