Abstract:Strong wall effects exist in packed beds with small tube-to-sphere diameter ratios because of the large void fraction near the wall,and the flow characteristics are of fundamental interest and valuable for engineering applications.CFD simulation was conducted to analyze the complex flow fields in three different packed bed models.Detailed investigation was carried out into the non-homogeneity resulting from wall effects.Based on two geometric models containing same number of spheres but packed randomly and in structure respectively,flow fields and especially near wall local flows were studied.Flow rate distribution on the transversal sectional planes determined by the large void fraction near wall was quantitatively investigated.It was found that flow rate through an annular area of 1/4 sphere radius wide near the wall was as high as 40% of the total flow rate,in a random packed bed with D/d=7.By intentionally increasing the near wall gap of the random bed and structured bed to half of sphere radius both containing 244 spheres,wall effects were analyzed quantitatively and the near wall flow rate was found to be as high as 60% of the total flow rate(structured bed 61% and random bed 74%).The pressure drop in the two packed beds was found obviously higher than predicted with Ergun correlation,which was believed to be the contribution of viscous energy loss resulting from wall effects.The results might imply that wall effects in a packed bed with excessively large near-wall void fraction deteriorated the transport performance and reaction efficiency since no adequate fluid flowed through the core region in the bed.

Intensification of Random Packing Via CFD Simulation, PIV Measurement and Traditional Experiments

Studies on a New Random Packing—Plum Flower Mini Ring

Hydrodynamics of New Structured Packings: an Experimental and Micro-scale CFD Study

A new approach to intensify the structured packing

Study on Absorption Performance at High Liquid Loads using a Novel Random Packing: Super Mini Ring

Packing of Cylindrical Particles: DEM Simulations and Experimental Measurements

3D CFD simulation of the liquid flow in a rotating packed bed with structured wire mesh packing

CFD Simulation of Flow and Mass Transfer in Structured Packing Distillation Columns

Study on Performance of QH-1 Mini Ring Packing at high Liquid-Gas Ratio

Research and development of advanced structured packing in a rotating packed bed

Liquid dispersion behaviors in a rotating packed bed with different packing arrangements: A comparison study

Investigation of countercurrent flow profile and liquid holdup in random packed column with local CFD data

Effect of Packing Structure Evolution on the Flow Characteristics in a Binary Composite Packed Bed Based on DEM-CFD Method

On Liquid Flow Maldistribution through Investigation of Random Open-Structure Packings

Hydrodynamics and Mass Transfer in a Pulsed Packed Column

CFD Analysis of Wall Effects in Packed Beds with Small Tube-to-sphere Diameter Ratio

Direct-Contact Condensation of Hydrocarbon Mixtures in A Structured Packing Bed

Computational fluid dynamic simulation of gas-liquid flow in rotating packed bed: A review

CFD simulation of the PACK-860X

Three-dimensional Computational Fluid Dynamics Modeling of Two-phase Flow in a Structured Packing Column

Experimental research on structured packing with smaller channel opening angle