Abstract:A general two-dimensional (2D) theoretical approach capable of providing an explicit closed-form solution is developed for the calculation of elastic stresses in single-lap adhesive bonded joints, assuming linear distribution of a longitudinal normal stress in the joint thickness direction. By treating the adhesive layer in the same way as the adherends, the two-dimensional stress and strain distributions at any point, and the tensile force, shearing and bending moment at any cross section can be predicted accurately, in both the adhesive and adherends. This makes it possible for the subsequent failure analysis of the bonded joints to predict all the main modes such as adherend failure, cohesive failure and adhesive failure. The analysis is based on a two-dimensional elasticity theory that both includes the complete stress-strain and the complete strain-displacement relationships for the adhesive and adherends. Then, through the use of the displacement continuity conditions at the interfaces between the adhesive and adherends, four coupled, fifth-order ordinary differential equations with constant coefficients for the determination of the stresses are developed. The proposed method is capable of satisfying all the boundary stress conditions of the joint, including the stress-free surface condition at the ends of the bondline. The calibration of the new theoretical approach was verified by comparing it with the previously theoretical solutions, and the 2D geometrically nonlinear finite element models with the rotation and non-rotation boundary conditions. It is indicated that the present solution can provide a good prediction for the stress and strain distributions in the adhesive and adherends. A different approach is also established for determining bending moment factor of the short joints wherein the consideration of overall joint moment equilibrium is emphasized. It was shown that when the proposed bending moment factor is adopted instead of the original one, the classical solution by Goland and Reissner (1944) [4] might still remain applicable to the adherends and adhesive even with the parameter E3t1/(E1t3) 0.1.

Vibration Analysis of Single Lap Adhesive Joint with Non-Uniform Adhesive Thickness: Experimental and Analytical Investigation

Viscoelastic Bilinear Cohesive Model and Parameter Identification for Failure Analysis of Adhesive Composite Joints

Evaluation of the cracked lap shear test for mixed-mode fracture toughness estimation of adhesive joints

Numerical Studies of Adherend Thickness Influence on the Response of Single Lap Joint under Longitudinal Load

Numerical Simulation and Experimental Study of Tensile Shear Performance of Adhesively Bonded Single-Lap Joint

Interfacial shear stress analysis in single-lap adhesive joints with similar and dissimilar adherends under dynamic loading

Numerical Study of Transverse Impact Response of Single-Lap Adhesively Bonded Joint

A Two-Dimensional Approach of Single-Lap Adhesive Bonded Joints

Influence of Adhesive Layer Properties on Laser-Generated Ultrasonic Waves in Thin Bonded Plates

Elastic Stress Analysis of Single-Lap Adhesive-Bonded Joints

Damage mode identification of adhesive composite joints under hygrothermal environment using acoustic emission and machine learning

Influences of adherent thickness, temperature and velocity on strength of adhesively-bonded single-lap joints

Simplified Finite Element Formulation of Unsymmetrical Adhesive Joints Based on Analytical Solutions

Static Analysis for Weld-Bonded Single-Lap Shear Joint with Multiple Weldspots

Influence of 3D printed adherend design on structural performance and vibrational behaviour of adhesively bonded joints

Closed-form solutions for elastic stressstrain analysis in unbalanced adhesive single-lap joints considering adherend deformations and bond thickness

Experimental Investigation of the Mechanical Behavior of Aluminum Adhesive Joints under Mixed-Mode Loading Conditions

Viscoelastic-adhesive modeling of hybrid adhesively bonded double-lap joints: analytical and numerical studies

Enforcing of an theoretical solution of three adhesive joints into simplified finite element formulations for stiffness prediction

On the Intralaminar and Interlaminar Stress Analysis of Adhesive Joints in Plated Beams

Study on the Mechanical Behavior of Adhesive Interface by Digital Image Correlation