Abstract:The technique of laser-generated and laser-detected Lamb waves is a powerful tool for characterizing elastic property of plates. However, the transient waveforms depend strongly on the longitudinal acoustic wavelength L and the plate thickness H. For a thick plate (bulk material), L/H≪1, a typical waveform consists of arrivals of longitudinal, shear, and surface wave pulses, if a detecting position is localized at the same side as the exciting laser beam. For a very thin plate L/H≫1, the transient waveform is characterized by the lowest Lamb wave modes, i.e., the first arrival of the spike signal from the lowest symmetric mode, and higher frequencies and the later lower frequency signal of the lowest antisymmetric mode. However, for thicker plates (H∼2.0 mm), the transient waveforms excited by a laser pulse are much more complicated, because of contributions of the higher-order Lamb wave modes, due to lower cut-off frequency. Thus, it is necessary to clarify theoretically dynamic response of the thicker composite plates for analyzing anisotropic behavior and extracting elastic constants of composite plates by fitting comparison of theory with experimental waveforms. In this paper, the theoretical and experimental studies are presented for a titanium graphite composite plate with thickness 1.44 mm, which can be modeled as transversely isotropic. The ultrasonic Lamb waves are excited by a laser pulse with an approximate duration of 10 nsec and energy of 5.7 mJ. The normal surface velocity of the ultrasonic Lamb waves are detected by a Michelson interferometer in fiber and cross fiber propagating directions for different propagating distances away from the excited laser to investigate the anisotropic property of the composite material and propagation characteristics of the ultrasonic Lamb waves. The results show that the detected waveforms consist of several Lamb wave modes and the theoretical calculations are in agreement with experiments.

Influence of Adhesive Layer Properties on Laser-Generated Ultrasonic Waves in Thin Bonded Plates

Characterizing the Properties of Adhesive in Bonded Materials by Laser Ultrasonic Method

Effect of Variable Cross-Section Rod on Laser-Induced Surface Acoustic Waves.

Laser-Generated Lamb Waves Propagation in Multilayered Plates Composed of Viscoelastic Fiber-reinforced Composite Materials

Influences of Elastic and Viscous Moduli on Laser-Generated Lamb Waves in Viscoelastic Plates

Thermoviscoelastic Finite Element Modeling of Laser-Generated Ultrasound in Viscoelastic Plates

Influence of Viscoelastic Property on Laser-Generated Surface Acoustic Waves in Coating–substrate Systems

Modelling of Laser-Generated Guided Waves in Bonded Plates with A Weak Interface by the Two-Layer Normal Mode Expansion Method

Mechanisms of Laser-Generated Ultrasound in Plates

Laser-Generated Rayleigh Waves Propagating in Transparent Viscoelastic Adhesive Coating/Metal Substrate Systems

Experimental and Theoretical Analyses on Laser-Generated Transient Lamb Waves in an Orthotropic Plate

Modeling Laser-Generated Guided Waves in Bonded Plates by the Finite Element Method

Effect of laser pre-treatment on adhesive joint performance and evaluation of interfacial strain distribution using mechanoluminescence

Quantitative Theory for Laser-Generated Lamb Waves in Orthotropic Thin Plates

Thin-Film Adhesion Measurement Using Laser-Generated High-Power Surface Acoustic Wave

Experimental and theoretical studies on laser treatment strategies for improving shear bonding strength of structural adhesive joints with cast aluminum

Investigation of interfacial stiffnesses of a tri-layer using Zero-Group Velocity Lamb modes

Anisotropic Behavior Analyzed by Laser-Generated Lamb Waves for Fiber Composite Plates

Theory of Laser-Generated Transient Lamb Waves in Orthotropic Plates

Normal Mode Expansion Method for Laser-Generated Ultrasonic Lamb Waves in Orthotropic Thin Plates

Near-field characteristics of laser-generated transient Lamb wave in thin plates