Abstract:Conventional ultrasound inspection has been a standard non-destructive testing method for providing an in-service evaluation and noninvasive means of probing the interior of a structure. In particular, measurement of the propagation characteristics of Lamb waves allows inspection of plates that are typical components in aerospace industry. A rapid, complete non-contact hybrid approach for excitation and detection of Lamb waves is presented and applied for non-destructive evaluation of composites. An air-coupled transducer (ACT) excites ultrasonic waves on the surface of a composite plate, generating different propagating Lamb wave modes and a laser Doppler vibrometer (LDV) is used to measure the out-of-plane velocity of the plate. This technology, based on direct waveform imaging, focuses on measuring dispersive curves for A0 mode in a composite laminate and its anisotropy. A two-dimensional fast Fourier transform (2D-FFT) is applied to out-of-plane velocity data captured experimentally using LDV to go from the time-spatial domain to frequency-wavenumber domain. The result is a 2D array of amplitudes at discrete frequencies and wavenumbers for A0 mode in a given propagation direction along the composite. The peak values of the curve are then used to construct frequency wavenumber and phase velocity dispersion curves, which are also obtained directly using Snell’s law and the incident angle of the excited ultrasonic waves. A high resolution and strong correlation between numerical and experimental results are observed for dispersive curves with Snell’s law method in comparison to 2D-FFT method. Dispersion curves as well as velocity curves for the composite plate along different directions of wave propagation are measured. The visual read-out of the dispersion curves at different propagation directions as well as the phase velocity curves provide profiling and measurements of the composite anisotropy. The results proved a high sensitivity of the air-coupled and laser ultrasound technique in non-contact characterization of Lamb wave dispersion and material anisotropy of composite plates using simple Snell’s law method.

Laser-Generated Lamb Waves Propagation in Multilayered Plates Composed of Viscoelastic Fiber-reinforced Composite Materials

Influence of Adhesive Layer Properties on Laser-Generated Ultrasonic Waves in Thin Bonded Plates

Anisotropic Behavior Analyzed by Laser-Generated Lamb Waves for Fiber Composite Plates

Influences of Elastic and Viscous Moduli on Laser-Generated Lamb Waves in Viscoelastic Plates

Microstructure Effects On Laser-Generated Lamb Waves In A Composite Plate

Propagation Characteristics of Laser-Generated Rayleigh Waves in Coating-Substrate Structures with Anisotropic and Viscoelastic Properties

Thermoviscoelastic Finite Element Modeling of Laser-Generated Ultrasound in Viscoelastic Plates

The Effect Of Fiber Orientation On Lamb Wave Propagation In Layered Anisotropic Composite Plates

Experimental and Theoretical Analyses on Laser-Generated Transient Lamb Waves in an Orthotropic Plate

Multiple crossing points of Lamb wave propagating in a magneto-electro-elastic composite plate

Transmission of Lamb wave in a micro-mechanically piezoelectric fiber-reinforced composite plate

Lamb Waves Propagation Characteristics in Functionally Graded Sandwich Plates

Mode Analyses of Laser-Generated Transient Ultrasonic Lamb Waveforms in A Composite Plate by Wavelet Transform

Attenuation characteristics of Lamb wave in carbon fiber reinforced composite laminated plate

Thermoviscoelastic Excitation and Propagation of Rayleigh Waves in Viscoelastic Plates by a Pulsed Laser

Lamb wave dispersion and anisotropy profiling of composite plates via non-contact air-coupled and laser ultrasound

Laser-Generated Rayleigh Waves Propagating in Transparent Viscoelastic Adhesive Coating/Metal Substrate Systems

Theory of Laser-Generated Transient Lamb Waves in Orthotropic Plates

The band structures of guided waves in periodically piezoelectric composite plate with a mirror plane (Conference Presentation)

Theory of laser-generated ultrasonic transient lamb waveform in orthotropic plates

Effect of Sinusoidal Fiber Waviness on Non-Linear Dynamic Performance of Laminated Composite Plates with Variable Fiber Spacing