Abstract:A general two-dimensional (2D) theoretical approach capable of providing an explicit closed-form solution is developed for the calculation of elastic stresses in single-lap adhesive bonded joints, assuming linear distribution of a longitudinal normal stress in the joint thickness direction. By treating the adhesive layer in the same way as the adherends, the two-dimensional stress and strain distributions at any point, and the tensile force, shearing and bending moment at any cross section can be predicted accurately, in both the adhesive and adherends. This makes it possible for the subsequent failure analysis of the bonded joints to predict all the main modes such as adherend failure, cohesive failure and adhesive failure. The analysis is based on a two-dimensional elasticity theory that both includes the complete stress-strain and the complete strain-displacement relationships for the adhesive and adherends. Then, through the use of the displacement continuity conditions at the interfaces between the adhesive and adherends, four coupled, fifth-order ordinary differential equations with constant coefficients for the determination of the stresses are developed. The proposed method is capable of satisfying all the boundary stress conditions of the joint, including the stress-free surface condition at the ends of the bondline. The calibration of the new theoretical approach was verified by comparing it with the previously theoretical solutions, and the 2D geometrically nonlinear finite element models with the rotation and non-rotation boundary conditions. It is indicated that the present solution can provide a good prediction for the stress and strain distributions in the adhesive and adherends. A different approach is also established for determining bending moment factor of the short joints wherein the consideration of overall joint moment equilibrium is emphasized. It was shown that when the proposed bending moment factor is adopted instead of the original one, the classical solution by Goland and Reissner (1944) [4] might still remain applicable to the adherends and adhesive even with the parameter E3t1/(E1t3) 0.1.

Numerical Simulation and Experimental Study of Tensile Shear Performance of Adhesively Bonded Single-Lap Joint

Numerical simulation of influence factors of stress distribution of weld-bonded joint under peeling load

Parametric Investigation into the Shear Strength of Adhesively Bonded Single-Lap Joints

Viscoelastic Bilinear Cohesive Model and Parameter Identification for Failure Analysis of Adhesive Composite Joints

Evaluation of the cracked lap shear test for mixed-mode fracture toughness estimation of adhesive joints

Numerical studies on the stress distribution in weldbonded joints with different adhesives

Study on the Mechanical Behavior of Adhesive Interface by Digital Image Correlation

Influences of adherent thickness, temperature and velocity on strength of adhesively-bonded single-lap joints

A Two-Dimensional Approach of Single-Lap Adhesive Bonded Joints

Investigation on shear and fatigue performance of CFRP/aluminum alloy single-lap adhesive joint

Shear behaviour of structural silicone adhesively bonded steel-glass orthogonal lap joints

Modelling of Deformation and Failure of Crash Toughened Adhesive Bonded Lap Shear Joints

Experimental study of strain rate effects on the strength of adhesively bonded joints after hygrothermal exposure

A Study on the Role of Adhesives in Weld-Bonded Joints

Experimental and Numerical Study of Low-Velocity Impact and Tensile after Impact for CFRP Laminates Single-Lap Joints Adhesively Bonded Structure

Elastic Stress Analysis of Single-Lap Adhesive-Bonded Joints

Interfacial shear stress analysis in single-lap adhesive joints with similar and dissimilar adherends under dynamic loading

Multiaxial stress effects on bonding strength in adhesively bonded joints

Enforcing of an theoretical solution of three adhesive joints into simplified finite element formulations for stiffness prediction

The effects of environments and adhesive layer thickness on the failure modes of composite material bonded joints

Effects of adherend notching on the bonding performance of composite single-lap joints