Abstract:A general two-dimensional (2D) theoretical approach capable of providing an explicit closed-form solution is developed for the calculation of elastic stresses in single-lap adhesive bonded joints, assuming linear distribution of a longitudinal normal stress in the joint thickness direction. By treating the adhesive layer in the same way as the adherends, the two-dimensional stress and strain distributions at any point, and the tensile force, shearing and bending moment at any cross section can be predicted accurately, in both the adhesive and adherends. This makes it possible for the subsequent failure analysis of the bonded joints to predict all the main modes such as adherend failure, cohesive failure and adhesive failure. The analysis is based on a two-dimensional elasticity theory that both includes the complete stress-strain and the complete strain-displacement relationships for the adhesive and adherends. Then, through the use of the displacement continuity conditions at the interfaces between the adhesive and adherends, four coupled, fifth-order ordinary differential equations with constant coefficients for the determination of the stresses are developed. The proposed method is capable of satisfying all the boundary stress conditions of the joint, including the stress-free surface condition at the ends of the bondline. The calibration of the new theoretical approach was verified by comparing it with the previously theoretical solutions, and the 2D geometrically nonlinear finite element models with the rotation and non-rotation boundary conditions. It is indicated that the present solution can provide a good prediction for the stress and strain distributions in the adhesive and adherends. A different approach is also established for determining bending moment factor of the short joints wherein the consideration of overall joint moment equilibrium is emphasized. It was shown that when the proposed bending moment factor is adopted instead of the original one, the classical solution by Goland and Reissner (1944) [4] might still remain applicable to the adherends and adhesive even with the parameter E3t1/(E1t3) 0.1.

A Study on the Role of Adhesives in Weld-Bonded Joints

Effects of elastic modulus and thickness of adhesives on the stress distribution in weld bonded joints

Numerical simulation of influence factors of stress distribution of weld-bonded joint under peeling load

Numerical studies on the stress distribution in weldbonded joints with different adhesives

Studies on the Stress Distribution and Fatigue Behavior of Weld-Bonded Lap Shear Joints

Comparative studies on stresses in weld-bonded, spot-welded and adhesive-bonded joints

Numerical analysis on effect of plate width on stress distribution in weldbonded joints

Elastic Stress Analysis of Single-Lap Adhesive-Bonded Joints

Studies on a computational model and the stress field characteristics of weld-bonded joints for a car body steel sheet

A Two-Dimensional Approach of Single-Lap Adhesive Bonded Joints

Numerical Simulation and Experimental Study of Tensile Shear Performance of Adhesively Bonded Single-Lap Joint

Static Analysis for Weld-Bonded Single-Lap Shear Joint with Multiple Weldspots

Influences of adherent thickness, temperature and velocity on strength of adhesively-bonded single-lap joints

Multiaxial stress effects on bonding strength in adhesively bonded joints

Dependence of fatigue limit on stress ratio and influence of cyclic stress on shear strength for an adhesive lap joint

Fatigue performance of bonding‐assisted fillet weld roots by inserting adhesive material

Stress and Strain Distribution and Strength of Weldbonded Joints with Two Spots

A TWO-DIMENSIONAL SOLUTION FOR UNSYMMETRIC SINGLE-LAP ADHESIVE BONDED JOINTS

Effect of Spot Pitch on Stress and Strain Distribution and Strength of Weldbonded Joints

Parametric Investigation into the Shear Strength of Adhesively Bonded Single-Lap Joints

Closed-form solutions for elastic stressstrain analysis in unbalanced adhesive single-lap joints considering adherend deformations and bond thickness