Abstract:A general two-dimensional (2D) theoretical approach capable of providing an explicit closed-form solution is developed for the calculation of elastic stresses in single-lap adhesive bonded joints, assuming linear distribution of a longitudinal normal stress in the joint thickness direction. By treating the adhesive layer in the same way as the adherends, the two-dimensional stress and strain distributions at any point, and the tensile force, shearing and bending moment at any cross section can be predicted accurately, in both the adhesive and adherends. This makes it possible for the subsequent failure analysis of the bonded joints to predict all the main modes such as adherend failure, cohesive failure and adhesive failure. The analysis is based on a two-dimensional elasticity theory that both includes the complete stress-strain and the complete strain-displacement relationships for the adhesive and adherends. Then, through the use of the displacement continuity conditions at the interfaces between the adhesive and adherends, four coupled, fifth-order ordinary differential equations with constant coefficients for the determination of the stresses are developed. The proposed method is capable of satisfying all the boundary stress conditions of the joint, including the stress-free surface condition at the ends of the bondline. The calibration of the new theoretical approach was verified by comparing it with the previously theoretical solutions, and the 2D geometrically nonlinear finite element models with the rotation and non-rotation boundary conditions. It is indicated that the present solution can provide a good prediction for the stress and strain distributions in the adhesive and adherends. A different approach is also established for determining bending moment factor of the short joints wherein the consideration of overall joint moment equilibrium is emphasized. It was shown that when the proposed bending moment factor is adopted instead of the original one, the classical solution by Goland and Reissner (1944) [4] might still remain applicable to the adherends and adhesive even with the parameter E3t1/(E1t3) 0.1.

Influence of 3D printed adherend design on structural performance and vibrational behaviour of adhesively bonded joints

Strength and failure assessments of 3D printed PLA single lap joints: Experimental and numerical analysis

Mechanical behavior investigation of fused deposition modeling joints by using different bonding geometry with variable adhesive thickness

Loading-rate effect on tensile and bending strength of 3D-printed polylactic acid adhesively bonded joints

Strength improvement and failure analysis of dissimilar FDM printed single-lap joints with tailored interface geometry

Mechanical strength of adhesively bonded joints using polymeric additive manufacturing

Enhancing shear strength in 3D printed single lap composite joints: A multi‐faceted exploration of GNP integration, print orientation, utilizing artificial neural networks, and dynamic analysis

Adhesive bonding of similar/dissimilar three-dimensional printed parts (ABS/PLA) considering joint design, surface treatments, and adhesive types

Crack propagation in adhesive bonded 3D printed polyamide: Surface versus bulk patterning of the adherends

Optimization of adherend thickness and overlap length on failure load of bonded 3D printed PETG parts using response surface method

Experimental and numerical study on mechanical behavior of 3D printed adhesive joints with polycarbonate substrates

Experimental study of the influence of adhesive reinforcement in lap joints for composite structures subjected to mechanical loads

Predicting static strength in adhesively bonded single lap joints using a critical distance based method: Substrate thickness and overlap length effects

Effects of adherend notching on the bonding performance of composite single-lap joints

A Two-Dimensional Approach of Single-Lap Adhesive Bonded Joints

Effect of bio-inspired surface texture on the resistance of 3D-printed polycarbonate bonded joints

Effects of impact fatigue on residual static strength of adhesively bonded joints

Mechanical Strength of Additive Manufactured and Standard Polymeric Components Joined Through Structural Adhesives

Influences of adherent thickness, temperature and velocity on strength of adhesively-bonded single-lap joints

Material and adhesive effect in adhesively-bonded composite stepped-lap joints

Parametric Investigation into the Shear Strength of Adhesively Bonded Single-Lap Joints