Thermal flue gas utilization in delivering unconventional geo-energy
Songyan Li,Rui Han,Zhoujie Wang,Zhaomin Li,Na Zhang,Kaiqiang Zhang
DOI: https://doi.org/10.1016/j.fuel.2021.123072
IF: 7.4
2022-04-01
Fuel
Abstract:Conventionally, thermal technology of steam-assisted gravity drainage (SAGD) has been an effective method to unlock unconventional petroleum resources with extra-high viscosity. However, in the middle and late stages of SAGD, there are some problems such as low oil production rate and high water cut, and a large amount of greenhouse gases can be generated, which may disrupt the balance of the geo-energy supply and greenhouse-gas mitigation. Therefore, in this study, with a novel thermal SAGD technology with flue gas in the late stage of SAGD, the steam chamber and fluid-steam ratio could be substantially improved, which thereafter results in better production performance. Meanwhile, it can effectively use the flue gas produced by SAGD to reduce carbon emissions. A laboratory-scale three-dimensional (3-D) physical was manufactured to simulate the practical processes, including interwell warm-up, conventional and novel flue gas-assisted SAGD at high-pressure and high-temperature reservoir conditions. The experiments demonstrated the injected flue gas concentrated on the top of the physical model due to the gravity override, which contributes to control the heat loss to the atmosphere and subsurface systems. In this way, the thermal sweep efficiency was substantially increased since the heat retained was employed for the lateral-direction steam chamber development. Meanwhile, the addition of flue gas induced the reduction of steam partial pressure, which finally resulted in chamber temperature decreasing by approximately 10 °C. On the other hand, the instantaneous fluid-steam ratio was found to increase from 0.06 to 0.24 at the highest, while the water cut decreased by around 20%. All the aforementioned changes in physical parameters contribute to 7.75% higher petroleum fluid recovery. Overall, the newly-developed technology has been validated to significantly extend production lifetime and improved recovery efficiency. This study will support the foundation of more general application pertaining to greenhouse gases mitigation and sustainable productions in unconventional geo-energy.
energy & fuels,engineering, chemical