Abstract:It can provide theoretical support for the optimal design of low-energy walls by measuring the actual thermal conditions inside the walls of passive low-energy buildings and studying the rationality of the wall structure design. Taking the teaching and laboratory building of Shandong Jianzhu University as an example, this paper explores the method of using temperature and humidity sensor to measure the air temperature and humidity inside the wall to represent the solid temperature and humidity of the wall. Based on the measured data and calculation results, the rationality of the structure of the test external wall is analyzed from four aspects: the performance of insulation, the moisture drain performance of wall, the ability of preventing the penetration of the hot and humid air of the inner wall, and the waterproof performance of the outer wall. Results show that the external wall structure of polystyrene board (200 mm thick) for external insulation and thin plastering has good practical operation effect in three aspects of thermal insulation, internal moisture discharge, and external wall waterproof, which basically meets the design requirements of external wall of passive house in Germany. In terms of moisture protection of the inner wall, the inner wall of cement mortar (15 mm thick) may not be able to effectively prevent the infiltration of indoor hot and humid air. Thus, the insulation layer should be added into the external wall. In addition, the moisture inside the wall is obviously affected by the season. The drain performance of moisture inside the wall mainly occurs in the sweltering heat, and the drain direction is from the indoor side to the outdoor side. In the external insulation structure, there are two layers of graphite polystyrene plate (100 mm thick), and the insulation effect of polystyrene plate near the outdoor side is better than that near the indoor side. The combination of anticrack mortar (5 mm thick) and paint cannot completely prevent the infiltration of rainwater, but the infiltration of rainwater in the wall will be quickly discharged in a short time.

Configuration and Pyrological Performance of Self Thermal Insulating Blocks

Design and thermal performance analysis of self-insulation concrete compound blocks

Energy Efficiency For Airtightness And Exterior Wall Insulation Of Passive Houses In Hot Summer And Cold Winter Zone Of China

The Energy Saving Effect of Different Wall Insulation Configurations with the Intermittent and Compartmental Heating Method

The research for new material and new technology of exterior walls thermal insulation

The Influence of Wall Structures to Air Conditioner Energy Consumption Based on the Characteristics of Intermittent and Loculose Energy Use

THERMODYNAMIC PERFORMANCE TESTS FOR MATERIALS OF SELF-THERMALINSULATION WALLS IN HOT-SUMMER AND COLD-WINTER AREA

Influence of the Permeability of External Thermal Insulation on Concrete Wall Carbonization

Study on Thermal Performance in Winter of Building Envelope Walls Insulated with Expanded Polystyrene Board

A Comparative Study on the Self Heat-Insulation Wall of Aerated Concrete Blocks and the External Heat-Insulation Wall of Polystyrene Panels

Partial Insulation of Aerated Concrete Wall in Its Thermal Bridge Regions

Thermoeconomic analysis for building wall materials

Increase of energy performance of residential buildings with enclosing structures made of masonries with application of ceramic blocks

Study on Thermal Performance Measurement and Construction of Passive Exterior Wall with Low Energy: Teaching and Laboratory Building of Shandong Jianzhu University

Study on Temperature Cracks in the Concrete Hollow Pint-sized Block Buildings

A foamed cement blocks with paraffin/expanded graphite composite phase change solar thermal absorption material

Summer thermal and energy performances assessment of a modular hydronic thermal barrier wall for ultra-low energy buildings - A field experimental study

Thermal Insulating Concrete Wall Panel Design for Sustainable Built Environment

Numerical Study on Improving the Thermal Insulation Performance of Hollow Blocks by Optimizing the Holes Configuration

Experimental Study on the Thermal Performance of a Hollow Block Ventilation Wall

Ideal Thermal Conductivity of a Passive Building Wall: Determination Method and Understanding