Abstract:It can provide theoretical support for the optimal design of low-energy walls by measuring the actual thermal conditions inside the walls of passive low-energy buildings and studying the rationality of the wall structure design. Taking the teaching and laboratory building of Shandong Jianzhu University as an example, this paper explores the method of using temperature and humidity sensor to measure the air temperature and humidity inside the wall to represent the solid temperature and humidity of the wall. Based on the measured data and calculation results, the rationality of the structure of the test external wall is analyzed from four aspects: the performance of insulation, the moisture drain performance of wall, the ability of preventing the penetration of the hot and humid air of the inner wall, and the waterproof performance of the outer wall. Results show that the external wall structure of polystyrene board (200 mm thick) for external insulation and thin plastering has good practical operation effect in three aspects of thermal insulation, internal moisture discharge, and external wall waterproof, which basically meets the design requirements of external wall of passive house in Germany. In terms of moisture protection of the inner wall, the inner wall of cement mortar (15 mm thick) may not be able to effectively prevent the infiltration of indoor hot and humid air. Thus, the insulation layer should be added into the external wall. In addition, the moisture inside the wall is obviously affected by the season. The drain performance of moisture inside the wall mainly occurs in the sweltering heat, and the drain direction is from the indoor side to the outdoor side. In the external insulation structure, there are two layers of graphite polystyrene plate (100 mm thick), and the insulation effect of polystyrene plate near the outdoor side is better than that near the indoor side. The combination of anticrack mortar (5 mm thick) and paint cannot completely prevent the infiltration of rainwater, but the infiltration of rainwater in the wall will be quickly discharged in a short time.

A Comparative Study on the Self Heat-Insulation Wall of Aerated Concrete Blocks and the External Heat-Insulation Wall of Polystyrene Panels

The research for new material and new technology of exterior walls thermal insulation

Design and thermal performance analysis of self-insulation concrete compound blocks

The Energy Saving Effect of Different Wall Insulation Configurations with the Intermittent and Compartmental Heating Method

EFFECT OF MASONRY MORTAR ON THERMAL INSULATION OF AAC MASONRY

Influence of the Permeability of External Thermal Insulation on Concrete Wall Carbonization

Structural Optimization and Application Research of Alkali-Activated Slag Ceramsite Compound Insulation Block Based on Finite Element Method

THERMODYNAMIC PERFORMANCE TESTS FOR MATERIALS OF SELF-THERMALINSULATION WALLS IN HOT-SUMMER AND COLD-WINTER AREA

The effect of thermal insulation from autoclaved aerated concrete on the energy performance of a single-family house

The Study on the Influence of Elastic Modulus of Insulation Mortar on Temperature Stress of Composite Self-Heat-conserving Wall

On the Seismic Performance of Autoclaved Aerated Concrete Self-Insulation Block Walls

Study on the heat and moisture transfer characteristics of aerogel-enhanced foam concrete precast wall panels and the influence of building energy consumption

Thermal Performance of Double Walls With Polystyrene Bead Insufflation

Numerical Analysis on Thermal Behavior of Composite Wall Combined Autoclaved Aerated Concrete With Thermal Insulting Material in Summer Day

Study on Thermal Performance Measurement and Construction of Passive Exterior Wall with Low Energy: Teaching and Laboratory Building of Shandong Jianzhu University

A comparative analysis of compression bearing capacity in recycled concrete brick walls and composite walls incorporating coal-ash blocks

Thermal and Structural Behaviour of Sandwiched Reinforced Cement Concrete Wall Panels

Comparative Thermal Evaluation of Two Systems of Wall Panels Exposed to Hot and Arid Arabian Environmental Weather Conditions

Experimental Study on Optical and Thermal Characteristics of Aerogel Glazing System under Real Climate Condition

A foamed cement blocks with paraffin/expanded graphite composite phase change solar thermal absorption material

Comparative Studies on the Temperature Stresses in External Walls with Different Thermal Insulation Models