Abstract:International Journal of Protective Structures, Ahead of Print. Split Hopkinson pressure bar (SHPB) system is significantly used for dynamic material characterization in the range of strain rates 102–104 s-1; however, there is no standard design methodology or readily available technique for the development of this apparatus. The objective of this study is to present a detailed design, development and calibration of SHPB apparatus for dynamic material characterization of concrete in compression. The calibration of the loading and bar components has been presented with the help of experimental results and validated following an analytical approach for one-dimensional stress wave propagation. The experimental pulse duration, 124.5 microsecond, and elastic wave speed, 4820 m/s, was measured with 2% deviation from the analytical results. Under three different impact velocities, a minimum 1.09% and maximum 4.14% decrement was observed in the incident wave as compared to analytical formulation. The recorded strain signals were captured in the transmission bar with a decrement of 1, 3, and 3.3% in peak strain when compared to the incident bar, at 4.5, 4.9, and 5.7 m/s impact velocities. The incident and transmission bars had almost identical wave characteristics demonstrating that the bar system has been perfectly and precisely aligned, and almost complete wave transfer is seen to have occurred. Experiments performed on M35 concrete specimens using the developed SHPB setup have been presented and discussed. The results demonstrated that the developed SHPB setup is capable to provide accurate results for the dynamic material characterization of concrete at high strain rate loading.

Experimental Study on Split Hopkinson Pressure Bar Pulse-Shaping Techniques for Concrete

Compressive Impact Tests of Lightweight Concrete with 155-Mm-diameter Spilt Hopkinson Pressure Bar

Experimental study on pulse shaping techniques of large diameter SHPB apparatus for concrete

Dynamic Behavior of Reactive Powder Concrete in Split Hopkinson Pressure Bar Testing

Experimental Investigation on the Dynamic Compressive Behavior of Rubberized Concrete

High-strain Rate Compressive Behavior of CFRP Confined Concrete: Large Diameter SHPB Tests

Large Dimension Hopkinson Pressure Bar and Its Application

Wave Separation Technique Applied to Impact Compressive Experiment of Concrete

Strength of Concrete Filled Steel Tubes under High-Strain Rate Loading

Design, development, and calibration of split Hopkinson pressure bar system for Dynamic material characterization of concrete

Dynamic compressive and splitting tensile tests on mortar using split Hopkinson pressure bar technique

The Application Development of Experimental Technique of Hopkinson Pressure Bar

Design and Calibration of a Large-Scale 155-mm Split-Hopkinson Pressure Bar

Experimental Techniques for Studying Dynamic Mechanical Behaviors of Concrete

Strain rate effect of concrete based on split Hopkinson pressure bar (SHPB) test

Experimental and Numerical Studies on the Dynamic Behaviors of Concrete Material Based on the Waveform Features in SHPB Test

Compressive Strength of Concrete Cores under High Strain Rates

Pulse Design of Constant Strain Rate Loading in SHPB Based on Pulse Shaping Technique

On the use of SHPB techniques to determine the dynamic behavior of materials in the range of small strains

Dynamic Brazilian Test of Concrete Using Split Hopkinson Pressure Bar

Wave dispersion analysis and simulation method for concrete SHPB test in peridynamics