Abstract:Catalytic upgrading of volatiles is an essential technology to improve the product distribution of pyrolysis for the clean and efficient utilization of low-rank coals. In this work, novel acid-base bifunctional catalysts composed of Ni/Li/Al oxides were designed and prepared using LDH precursors with tunable chemical composition and structural properties. The catalysts were systematically characterized by X-ray diffraction (XRD), thermogravimetric analysis (TGA), physisorption, NH 3 -temperature programmed desorption (NH 3 -TPD), CO 2 -temperature programmed desorption (CO 2 -TPD), H 2 -temperature programmed reduction (H 2 -TPR), and scanning electron microscopy-energy dispersive X-ray spectroscopy (SEM-EDS). A two-stage fixed bed reactor was employed to evaluate the performance of the catalysts. Characterization results suggest that the crystal size of NiO and the surface area of the catalyst decreased with increasing Li content and decreasing Ni content in the catalyst, while the pore volume and pore diameter were positively correlated with Li content. Moreover, the addition of Li reduced the amount of weak acid sites and raised the amount of total basic sites. Consequently, the bifunctional catalysts boosted the yield of light tar and the contents of aromatics and phenols in tar. Specifically, with the highest total acid sites (569 μmol/g) promoting the cracking of heavy pitch components, Ni 2.5 Li 0.5 Al 1 decreased the content of pitch in tar to 23.8 wt%, representing a 42.7 % drop from the corresponding non-catalytic pyrolysis. Accordingly, it improved the light tar yield to 7.2 wt%, which was 18 % higher than non-catalytic pyrolysis. 450 °C is identified as a suitable temperature for the catalytic upgrading of volatiles from Naomaohu coal; higher catalysis temperatures at 500 °C and 550 °C led to lower tar yield and lower phenols content, along with higher gas yield and more carbon deposition.

Catalytic Hydrocracking of a Bitumen‐Derived Asphaltene over NiMo/γ‐Al2O3 at Various Temperatures

Molar Kinetics in Catalytic Hydrocracking of Asphaltenes

Lumping Kinetics of Asphaltene Hydrocracking over Nimo/Gamma-Al2o3

Investigation on asphaltene compositions and structures during hydroprocessing of low-temperature coal tar at different reaction temperatures on Ni–Mo–W/γ–Al2O3 catalysts

Hydrocracking of Polyolefin Thermal Cracking Waxes Over Ni-loaded Molecular Sieve Catalysts

Hydrocracking of Bio-Alkanes over Pt/Al-MCM-41 Mesoporous Molecular Sieves for Bio-Jet Fuel Production

Catalytic Cracking of Arab Super Light Crude Oil to Light Olefins: An Experimental and Kinetic Study

Hydrocracking of vacuum residue in a slurry phase reactor: effect of reaction temperature and properties of feedstock

Catalytic upgrading of Naomaohu coal pyrolysis volatiles over NiAl and NiLiAl oxides

A Study on the Pyrolysis of Asphalt

Thermodynamics and Kinetics Insights into Naphthalene Hydrogenation over a Ni-Mo Catalyst

Kinetics and Product Distributions for Thermal Cracking of a Kerosene-Based Aviation Fuel

LUMPING KINETIC MODEL OF HIGH TEMPERATURE COAL TAR HYDROCRACKING

Kinetic and reaction pathway of upgrading asphaltene in supercritical water

Performance of catalytic cracking of biomass tar and catalyst preparation

Heterogeneous Cracking Reaction of Tar over Biomass Char, Using Naphthalene As Model Biomass Tar

Reaction network and thermodynamic equilibrium for tetralin hydrocracking over NiMo/HY catalyst

THE REACTION PATHS OF CHARACTERISTIC PRODUCTS FROM MONOMOLECULAR AND BIMOLECULAR CRACKING REACTION OF HEAVY FRACTIONS OF FCC GASOLINE II.The Formation Paths of Characteristic Products over Different Type Catalysts

The Steam Reforming of Naphthalene over a Nickel–dolomite Cracking Catalyst

Structure-performance Relationship of NiMo/Al2O3-HY Catalysts in Selective Hydrocracking of Poly-Aromatics to Mono-Aromatics

Catalytic Cracking of Light Crude Oil to Light Olefins and Naphtha over E-Cat and MFI: Microactivity Test versus Advanced Cracking Evaluation and the Effect of High Reaction Temperature