Abstract:Acoustical methods are playing an important role for nondestructive evaluation (NDE) of adhesive-bonded composites and components in industrial applications. A dual-frequency ultrasonic technique is proposed for the quantitative evaluation of contact strength between pressed solid surfaces. An ultrasonic excitation consists of two primary frequency components is applied perpendicular to the interface, and the transmitted wave is examined. Theoretical study is based on a perturbation analysis of contact acoustic nonlinearity (CAN) model, predicting the generation of difference and sum frequency waves, together with the second harmonics. Nonlinear parameters are defined to describe the nonlinearity generation efficiencies. Experiments are performed for three types of interfaces, i. e. the interfaces of two aluminum alloy blocks with and without couplant and two glass blocks. The difference frequency wave component has bigger generation efficiency than other nonlinear components, which offers an advantage of high SNR and good detection capability of contact stiffness (interfacial stiffness). For each interface, the first and second-order interfacial stiffness are measured with contact pressure increasing from near zero to about 0.8 MPa with the aid of a laser interferometer. Finally, numerical simulations are also carried out, and a consistency is found between measurements and calculations. The dual-frequency ultrasound sent to the interface generates at least four second-order nonlinear components, which enriches the CAN technique for interface quality examinations. Both measured and simulated results indicate an increase of interfacial stiffness and decrease of nonlinear parameters with growing contact pressure. Moreover, measured results show that couplant between interfaces influences the contact stiffness evaluations in an enhanced manner, while the contact pressure determined by measured interfacial stiffness values are underestimated due to the couplant. The main problem comes from the contact between the transducersample interfaces, which brings extra nonlinearity to the detected signals and affect the accuracy of measuring. Copyright© (2010) by the International Congress on Acoustics.

A Reflective Nonlinear Acoustic Microscope to Contour the Quantitative Adhesion at A Bonded Solid-Solid Interface

Nondestructive Characterization of Quantitative Bonding Strength at A Bonded Solid-Solid Interface

A Unique Method to Describe the Bonding Strength in a Bonded Solid–Solid Interface by Contact Acoustic Nonlinearity

Contact acoustic nonlinearity in a bonded solid–solid interface

Numerical studies on deformation and adhesion behaviour of substrate during nanoindentation

Evaluation of contact stiffness between solid-solid interfaces using dual-frequency ultrasound

Interfacial Debonding Detection for Steel-Concrete Composite Structures Part II: Scanning Doppler Laser-Based MASW and Microphone Combination-Based Impact-Acoustic Vibration

Angular Measurement of Acoustic Reflection Coefficients by the Inversion of V(z, T) Data with High Frequency Time-Resolved Acoustic Microscopy

Characterizing the Properties of Adhesive in Bonded Materials by Laser Ultrasonic Method

Interfacial Debonding Detection for Steel-Concrete Composite Structures Part I: Benchmark Test and Signal Calibration of Contact and Non-Contact Measurement

Adhesion quantification methods for wafer bonding

Nanoindentation Mapping and Bond Strength Study of Adhesive–Dentin Interfaces

Thin-Film Adhesion Measurement Using Laser-Generated High-Power Surface Acoustic Wave

Simultaneous Thickness, Velocity, Density, and Attenuation Measurement of a Thin Layer by Time-Resolved Acoustic Microscopy

A Systematic Method for Characterizing the Elastic Properties and Adhesion of a Thin Polymer Membrane

Development of non-destructive bond monitoring techniques for ultrasonic bonders

Improvement of interface anchoring by ultrasonic vibration for adhesively bonded CFRP/Al joints

Oblique-incidence Ultrasonic Testing for the Adhesion Quality of Ceramic Coatings

Nonlinear harmonic wave-guided interfacial debonding identification in RC beams

Linear vs nonlinear ultrasonic testing of kissing bonds in adhesive joints

Three-Dimensional Microscale Imaging and Measurement of Soft Material Contact Interfaces Under Quasi-Static Normal Indentation and Shear.