Abstract:Nano-sized precipitate phases in normalized-and-tempered CLAM steel (HEAT-0912) before and after 3.5 MeV Fe 13+ ion irradiation at 400 degrees C to 0.61, 1.29 and 2.77 dpa were studied using transmission electron microscope and high-resolution transmission electron microscope. Six types of nanoprecipitate phases based on Cr23C6, 23 C 6 , TaC, Ta3C2, 3 C 2 , VC, Cr7C3, 7 C 3 , and V2C 2 C were identified in unirradiated steel. During irradiation, a large number of nano precipitates uniformly distributed in the matrix occurred, and the number density of nanoprecipitates initially increased and subsequently decreased with increasing the irradiation dose. Nanoscale Cr-rich M23C6, 23 C 6 , V-rich MX and M2X 2 X phases but no nanoscale phases based on TaC, Ta3C2 3 C 2 and Cr7C3 7 C 3 were identified in the steel irradiated up to 2.77 dpa. After irradiation, five types of irradiation-induced nanoscale new phases were identified in the irradiated steel. These include Fe-rich M3X2 3 X 2 (Cr3C2 3 C 2 types I and II) carbonitrides with the same simple orthorhombic lattice and totally different lattice parameters (approximately a/b/c = 1.146/0.552/0.2821 nm and 0.285/0.925/0.696 nm), Fe-rich M2C, 2 C, M3C 3 C and M5C2 5 C 2 carbides, but the occurrence of which under irradiation varied with the irradiation dose. Fe-rich M3X2 3 X 2 (Cr3C2 3 C 2 type I) and Fe-rich M5C2 5 C 2 phases were identified in the steel irradiated up to 1.29 dpa and only to 2.77 dpa, respectively. Fe-rich M2C 2 C and M3C 3 C in addition to Fe-rich M3X2 3 X (Cr3C2 3 C 2 type II) phases were identified in the steel irradiated up to 2.77 dpa. The irradiation-induced Fe-rich M3X2 3 X (Cr3C2 3 C 2 type I & II), M5C2 5 C 2 and M2C 2 C precipitates appear to be identified, for the first time, in reduced activation ferritic/martensitic steels including CLAM steel. The formation mechanism of these irradiation-induced precipitate phases is also discussed.

Microstructure and Microhardness of CLAM Steel Irradiated Up to 20.8 Dpa in STIP-V

Tensile Properties of Clam Steel Irradiated Up to 20.1 Dpa in Stip-V

Microstructural Evolution of CLAM Steel under 3.5 MeV Fe 13+ Ion Irradiation

Helium Irradiation-Induced Segregation and Mechanical Response in China Low Activation Martensitic (CLAM) Steel

Microstructure Evolution and Yield Strength of CLAM Steel in Low Irradiation Condition

Irradiation-induced Hardening and Softening of CLAM Steel under Fe Ion Irradiation

He and H Irradiation Effects on the Nanoindentation Hardness of CLAM Steel

Irradiation Damage of Reduced Activation Ferritic/martensitic Steel CLAM Exposed to Low-Energy High-Flux D + He Mixture Plasma

Effect of helium and its synergism with displacement damage on microstructure of CLAM steel investigated by single, sequential and simultaneous Fe and He ion irradiations

Proton irradiation defects in CLAM steel and their annealing behavior studied by slow positron beams

Effect of Post Weld Heat Treatment on the Microstructure and Properties of Laser-TIG Hybrid Welded Joints for CLAM Steel

Correlation between microstructure and hardening of 9Cr ferritic/martensitic steels irradiated in spallation neutron source

Deterioration of irradiation resistance of ODS-F/M steel under high concentration of helium

Irradiation-induced Phases in an Fe Ion Irradiated CLAM Steel

Hardening and Creep of Ion Irradiated CLAM Steel by Nanoindentation

Preliminary Experiments on the Corrosion of CLAM Steel in Flowing Eutectic LiPb

Effects of Yttrium and Heat Treatment on the Microstructure and Mechanical Properties of CLAM Steel

Identification of Nano-Sized Precipitates in CLAM Steel Induced by 3.5 MeV Fe13+13+ion Irradiation

Comprehensive improvement of strength and ductility in CLAM steel subjected to TEU: The role of heterogeneous microstructure

Identification of Nano-Sized Precipitates in CLAM Steel Induced by 3.5 MeV Fe13+ Ion Irradiation

Effect of Strain Rate on the Mechanical Properties of Clam Steel in Liquid Pbli Eutectic