Effect of Sizing Agents on Surface Properties of Carbon Fibers and Interfacial Adhesion of Carbon Fiber/Bismaleimide Composites
Tian Yang,Yan Zhao,Hansong Liu,Mingchen Sun,Shu Xiong
DOI: https://doi.org/10.1021/acsomega.1c01103
IF: 4.1
2021-09-01
ACS Omega
Abstract:Physicochemical, surface, and mechanical properties of three batches of T800 grade carbon fibers (CFs) treated with three kinds of sizing agents and Toray T800H CFs were characterized to study the effect of sizing agents on surface properties. Scanning electron microscopy for morphology, atomic force microscopy calculations, and results for the content of sizing agents showed that sizing agent B improved the surface roughness and CFs with high content of sizing agent always presented small surface roughness in a certain content range 1.2–1.6%. Surface energy of CFs was calculated by Young's contact angle using the test results with water and glycol, and contact angles with LY-1 and modified-AC531 were also acquired. The results proved that CFs of sizing agent group B had the highest average surface energy and the lowest average contact angles with both LY-1 and modified-AC531. From both single-filament and tensile strength test results, the average strength of CFs of sizing agent group B was found to be the lowest, which indicated that sizing agent B had an influence on tensile strength decrease of T800 grade CFs. Comparing the results of interfacial shear strength both in a natural dry state and after hygrothermal treatment, high surface energy was found to be the key element to obtain high interfacial adhesion between T800 grade CFs and bismaleimide, and high surface roughness and low contact angle also played important roles. Among sizing agents A, B, and C, A had an effect on the interfacial shear strength decrease of CFs in the natural dry state, while C had that after hygrothermal treatment.This article has not yet been cited by other publications.
chemistry, multidisciplinary