Abstract:The microstructure evolution of Ni-based superalloys during heat treatment is of great significance for obtaining better service performance. However, heat treatment experimentation is costly and time-consuming, and sometimes fails to reveal physical mechanisms well. In the present study, a multiphase-field model coupled with an explicit nucleation algorithm was established to simulate the precipitation and growth of γ′ phase in DD6 superalloy, which can be applied to a multicomponent elastic-inhomogeneous system. The PanNickel© database was used to calculate thermodynamic and kinetic data in multicomponent superalloys. First, the coupling method of multiphase-field model and explicit nucleation algorithm was introduced. The coupled model was used to simulate the precipitation of γ′ phase under isothermal and non-isothermal conditions. It was found that a unimodal microstructure was formed under isothermal conditions and there was a “soft impingement” phenomenon, while a bimodal distribution composed of cuboidal γ′ precipitates and fine secondary γ′ precipitates was formed during a cooling process of 25–125 °C/min. The effect of cooling rate was studied. Then, the chemical and elastic driving forces were analyzed. It was found that Al and Ta contributed most to the chemical driving force, while Re and W gathered at the γ/γ′ interface and inhibited the growth of γ′ phase. γ′ precipitates had a cuboidal shape under the influence of elastic driving force. Finally, the growth and coarsening process of γ′ phase was studied and compared with the well-known Lifshitz−Slyosov−Wagner (LSW) theory. The growth of γ′ phase can be divided into rapid growth, coarsening and quasi-static coarsening stages according to the simulation results, among which the coarsening stage is basically consistent with the LSW theory. The current model can be used to simulate the precipitation and growth of single crystal superalloys where multicomponent and elastic effects are considered.

Precipitation of Γ′ Phases During Slow Cooling of Nickel Based Superalloy

Influence of Cooling Rate on the Formation of Bimodal Microstructures in Nickel-Base Superalloys During Continuous Two-Step Aging

Growth behavior of γ′ phase in a powder metallurgy nickel-based superalloy under interrupted cooling process

Morphology Evolution of Γ′ Precipitates in a Powder Metallurgy Ni-base Superalloy

An Investigation of High-Temperature Precipitation in Powder-Metallurgy, Gamma/Gamma-Prime Nickel-Base Superalloys

The Effect of Cooling Rates from Temperatures above the Γ′ Solvus on the Microstructure of a New Nickel-Based Powder Metallurgy Superalloy

Effect of Cooling Rate on Precipitation Behavior of Gamma Prime in a Newly Developed Co-based Superalloy

Coarsening Transitional Kinetics of Γ′ Precipitates in a Nickel-Based Single Crystal Superalloy During Thermal Exposure

Early Stages of Precipitation in Γ' Phase of a Ni–Al–Ti Model Alloy: Phase-Field and First-Principles Study

Growth and dissolution behavior and morphology evolution of γ' precipitates in GH4742 nickel-based superalloy

Microstructures and Mechanical Properties of a L12-structured Precipitation Strengthened Co-based Superalloy

Precipitation and Growth Simulation of Γ′ Phase in Single Crystal Superalloy DD6 with Multiphase-Field Method and Explicit Nucleation Algorithm

Thermodynamic Simulation Calculation on Precipitation Behavior of Equilibrium Phases in a Low Re bearing Nickel based Single Crystal Superalloy

Atomic-scale computer simulation of mixture precipitation mechanism for Ni75AlxV25-x alloy

Solidification Behavior of Ni-based Superalloy at Different Cooling Rates

Precipitation and growth behavior of γ′ phase in Ni3Al-based superalloy under thermal exposure

Dendrite evolution and quantitative characterization of γ′ precipitates in a powder metallurgy Ni-based superalloy by different cooling rates

Spinodal Decomposition Versus Classical Gamma-Prime Nucleation in a Nickel-Base Superalloy Powder: An In-Situ Neutron Diffraction and Atomic-Scale Analysis

Precipitation behavior of γ′ phase with a multi-model morphology in the Ni-based superalloy GH4720Li during water quenching and subsequent artificial aging and related mechanisms

Influence Mechanism of Slow Cooling Treatment after Homogenization on Hot Deformation Behavior of a New Nickel-Based Superalloy

Gamma prime and TCP phases and mechanical properties of thermally exposed nickel-base superalloy