Abstract:Cross ventilation can effectively improve air quality with larger ventilation rate than single-sided natural ventilation. The measurement of ventilation rate is critical for research on indoor environmental maintenance and air quality control. This investigation compared four methods of obtaining the cross ventilation rate in a residence, including direct measurement by the tracer-gas-decay method, and indirect measurement with ultrasonic anemometers, from the wind speed at a reference position, and from the differential pressure between two sides of the residence. Furthermore, measured wind speed in the direction normal to the opening was used to analyze the unsteady and non-unidirectional flow characteristics, and the airflow consistency σ was found to be in the range of 50%–98%. The results show that when σ > 90%, the internal airflow was close to unidirectional flow, and the ventilation rates in all rooms were similar. As the ratio σ decreased, the error between the measured and calculated ventilation rate at the openings increased. When σ < 70% with severe non-unidirectional flow, the presumed ventilation volume based on the measured wind speed at one opening had a large deviation from the measured ventilation rate at the other. We then calculated the volume of air intake and outflow at the same opening. On the basis of volume conservation, the exchange ventilation rates between internal rooms were obtained by the tracer-gas-decay method combined with ultrasonic anemometers to measure the wind speed at the openings of the multi-zone dwellings. Therefore, single tracer-gas-decay method with ultrasonic anemometer at the openings can measure the cross ventilation rate and obtained the ventilation rate between internal rooms of the multi-zone residence.

A New Method to Assess the Infiltration Rate in Large Commercial Complex in Beijing, China

A New Method to Assess Infiltration Rates in Large Shopping Centers

Comparison of indoor concentration of PM2.5 between different residences

A Convenient Method to Assess Air Infiltration Rate Using Particle Mass Balance Principle

Air Infiltration Rate Distributions of Residences in Beijing

Field Measurement and Numerical Simulation of Air Infiltration from Entrances in an Airport in Winter

Field Study of Infiltration Rate and Its Influence on Indoor Air Quality in an Apartment

A new PM2.5-based CADR method to measure air infiltration rate of buildings

The Characteristics Of Infiltration Air In Large Space Buildings

Field Test and Calculation Methods of Infiltration Rate in Large Space Buildings such as Airport Terminals

Influencing Factors on Infiltration Rate of Heating Rooms in Hot Summer and Cold Winter Zone

Air infiltration rate distribution across Chinese five climate zones: A modelling study for rural residences

Air change rate measurements using indoor/outdoor ratio of pm2.5

Examination and Optimization of Classroom Indoor Environments in China’s Hot Summer and Cold Winter Regions

Comparison of Winter Air Infiltration and Its Influences Between Large-Space and Normal-Space Buildings

Measurement of Cross-Ventilation Rate in Urban Multi-Zone Dwellings

A Fast Method for Calculating the Impact of Occupancy on Commercial Building Energy Consumption

Air infiltration and related building energy consumption: A case study of office buildings in Changsha, China

Evaluation of Air Infiltration in a Hub Airport Terminal: On-site Measurement and Numerical Simulation

Comparison of Models to Predict Air Infiltration Rate of Buildings with Different Surrounding Environments

Theoretical Model of Buoyancy-Driven Air Infiltration During Heating/cooling Seasons in Large Space Buildings