Abstract:This paper analyzes a recently introduced two-motor five-phase drive system with series connection of stator windings. It has been shown, using physical reasoning, that the introduction of an appropriate phase transposition in the series connection of two machines leads to a complete decoupling of the flux/torque-producing currents of one machine from the flux/torque-producing currents of the second machine. Consequently, independent vector control of the two machines becomes possible while using a single current-controlled five-phase voltage source inverter as the supply. The drive system modeling and control are first elaborated in this paper by taking both machines as induction motors. It is shown, using rigorous mathematical derivations, that the independent control of the two machines results due to the placement of machines in two different subspaces of the five-dimensional space. This is enabled by phase transposition in series connection. The models of the complete drive in the stationary common reference frame and in the rotor-flux-oriented reference frames of the two machines are developed. An associated vector control scheme for the two-motor drive is presented next. The second part of this paper describes an experimental setup used further on to evaluate the dynamic behavior of the two-motor drive. Performance is investigated by extensive experimentation for various transients (acceleration, deceleration, reversing, and disturbance rejection). Excellent decoupling of control of the two machines is achieved. Both the concept of the drive and the approach to modeling and control are thus fully verified experimentally. Finally, the advantages and shortcomings of the series-connected five-phase two-motor drive are discussed, and potential application areas are highlighted.

An Efficient Control of A Series Connected Two-Synchronous Motor 5-Phase with Non Sinusoidal Emf Supplied by A Single 5-Leg Vsi: Experimental and Theoretical Investigations

Decoupled Vector Control Scheme for Dual-Armature Flux-Switching Permanent Magnet Machines

Current Control Scheme for LC-Equipped PMSM Drive Considering Decoupling and Resonance Suppression in Synchronous Complex-Vector Frame

A New Reactive Power-Based Sensorless Control Strategy For Five-Phase Induction Motor With Non-Sinusoidal Power Supply

Dual Closed-Loop Control Strategy on Harmonic Plane for Multiphase Induction Motor with Harmonic Injection Based on Air-Gap Flux Orientation Control

Modeling, Control, and Experimental Investigation of a Five-Phase Series-Connected Two-Motor Drive With Single Inverter Supply

Analysis, Simulation and Experimental Strategies of 5-Phase Permanent Magnet Motor Control

Steady-State Modeling of Series-Connected Five-Phase and Six-Phase Two-Motor Drives

Variable speed Control under Voltage and Current Limits of a 5-phase PMSM drive in Healthy and Open-Circuited Modes

Space Vector Pwm for Three Series-Connected Permanent Magnet Synchronous Motors Drive System

An Enhanced Fault-Tolerant Control of a Five-Phase Synchronous Reluctance Motor Fed from a Three-to-Five-phase Matrix Converter

Control with Sliding Mode of a Five-Phase Series-Connected Two-asynchronous Motor Drive

High-Precision Control For A Surface-Mounted Permanent Magnet Synchronous Motor Based On Inverse System Approach

An Improved Model Predictive Direct Torque Control Strategy for Reducing Harmonic Currents and Torque Ripples of Five-Phase Permanent Magnet Synchronous Motors.

Direct torque control of six-phase permanent magnet synchronous motor with double Y shifted 30°

A New Control Strategy of 5-Phase PM Motor under Open-Circuited Phase Based on High Order Sliding Mode and Current References Real-Time Generation

Direct Torque Model Predictive Control of a Five-Phase Permanent Magnet Synchronous Motor

A Novel Direct Torque Control Scheme for a Sensorless Five-Phase Induction Motor Drive

Sliding-mode control of a six-phase series/parallel connected two induction motors drive

Variable speed control of a 5-phase permanent magnet synchronous generator including voltage and current limits in healthy and open-circuited modes

Simulation of Direct Torque Control for Five-Phase PMSM and Comparison of Optimized Vector Tables