Abstract:This paper analyzes a recently introduced two-motor five-phase drive system with series connection of stator windings. It has been shown, using physical reasoning, that the introduction of an appropriate phase transposition in the series connection of two machines leads to a complete decoupling of the flux/torque-producing currents of one machine from the flux/torque-producing currents of the second machine. Consequently, independent vector control of the two machines becomes possible while using a single current-controlled five-phase voltage source inverter as the supply. The drive system modeling and control are first elaborated in this paper by taking both machines as induction motors. It is shown, using rigorous mathematical derivations, that the independent control of the two machines results due to the placement of machines in two different subspaces of the five-dimensional space. This is enabled by phase transposition in series connection. The models of the complete drive in the stationary common reference frame and in the rotor-flux-oriented reference frames of the two machines are developed. An associated vector control scheme for the two-motor drive is presented next. The second part of this paper describes an experimental setup used further on to evaluate the dynamic behavior of the two-motor drive. Performance is investigated by extensive experimentation for various transients (acceleration, deceleration, reversing, and disturbance rejection). Excellent decoupling of control of the two machines is achieved. Both the concept of the drive and the approach to modeling and control are thus fully verified experimentally. Finally, the advantages and shortcomings of the series-connected five-phase two-motor drive are discussed, and potential application areas are highlighted.

Sliding-mode control of a six-phase series/parallel connected two induction motors drive

Multi-level Converter-Based Torque Sharing Function Control Strategy for Switched Reluctance Motors

A Novel Sequential Direct Torque Control Scheme for Seven-phase Induction Motors

A Sequential Direct Torque Control Scheme for Seven-Phase Induction Machines Based on Virtual Voltage Vectors

Current Control Strategy of Electronic Pole-Changing for Multiphase Induction Motors

Dual Closed-Loop Control Strategy on Harmonic Plane for Multiphase Induction Motor with Harmonic Injection Based on Air-Gap Flux Orientation Control

Control with Sliding Mode of a Five-Phase Series-Connected Two-asynchronous Motor Drive

A PWM Strategy for Six-Phase Dual Stator Induction Motor Fed by Two Identical Voltage Source Inverters

Modeling, Control, and Experimental Investigation of a Five-Phase Series-Connected Two-Motor Drive With Single Inverter Supply

Fuzzy Sliding Mode Control for Synchronization of Multiple Induction Motors Drive

Steady-State Modeling of Series-Connected Five-Phase and Six-Phase Two-Motor Drives

Six-phase induction machine driven by the matrix converter

Modified Sliding Mode Observer-Based Direct Torque Control of Six-Phase Asymmetric Induction Motor Drive

The weighted synergetic speed control for single inverter, parallel-connected induction motor drive

Fault-Tolerant Control of Five-Phase Induction Motor under Single-Phase Open

Sliding Mode Pulse-Width Modulation-Based Direct Toque Control for Nine-Switch Inverter Dual-Induction Motor Drive

An Enhanced Sliding Mode Speed Control for Induction Motor Drives

Direct torque control based on second order sliding mode controller for three-level inverter-fed permanent magnet synchronous motor: comparative study

A full sliding mode sensorless control of three-level inverter-fed induction motors

Direct torque control of six-phase permanent magnet synchronous motor with double Y shifted 30°

Minimization of Capacitor Voltage Difference for Four-Leg Inverter Dual-Parallel IM System