Abstract:Introduction. The permanent magnet synchronous motor (PMSM) has occupied a large area in the industry because of various benefits such as its simple structure, reduced moment of inertia, and quick dynamic response. Several control techniques have been introduced for the control of the PMSM. The direct torque control strategy associated to three-level clamped neutral point inverter has been proven its effectiveness to solve problems of ripples in both electromagnetic torque and stator flux with regard to its significant advantages in terms of fast torque response. Purpose. The use of a proportional integral speed controller in the direct torque control model results in a loss of decoupling with regard to parameter fluctuations (such as a change in stator resistance value induced by an increase in motor temperature), which is a significant drawback for this method at high running speeds. Methods. That is way a second order sliding mode controller based on the super twisting algorithm (STA) was implemented instead of PI controller to achieve a decoupled control with higher performance and to insure stability while dealing with parameter changes and external disturbances. Results. The simulation results carried out using MATLAB/Simulink software show that the model of direct torque control based on a three-level inverter-fed permanent magnet synchronous motor drive has better performance with second order sliding mode speed controller than the proportional integral controller. Through the response characteristics we see greater performance in terms of response time and reference tracking without overshoots. Decoupling, stability, and convergence toward equilibrium are all guaranteed.

Sliding Mode Pulse-Width Modulation-Based Direct Toque Control for Nine-Switch Inverter Dual-Induction Motor Drive

A Novel Sequential Direct Torque Control Scheme for Seven-phase Induction Motors

Boost Inverter with Sliding Mode Control

Discrete-time Passivity-Based Sliding-Mode Control of Single-Phase Current-Source Inverter

Torque Ripple Suppression Method with Reduced Switching Frequency for Open-Winding PMSM Drives with Common DC Bus.

Realization of A Spwm Inverter for Multi-Phase Induction Motor Drives

Development and Analysis of Pulse Width Modulation Techniques for Induction Motor Control

Control Strategy for Open Winding PMSM System Supplied by the Z-source and Voltage Source Integrated Converters

Direct torque control based on second order sliding mode controller for three-level inverter-fed permanent magnet synchronous motor: comparative study

Sliding-mode control of a six-phase series/parallel connected two induction motors drive

The PMSM DTC Based on Variable Structure Sliding Mode

Extending DC Bus Utilization for Induction Motors with Stator Flux Oriented Direct Torque Control

Experimental Realization of a Novel 48-Sector Space Vector Decomposition-Based SVPWM Technique for A Six-Phase Two-Level VSI-Fed Six-Phase Asymmetrical Induction Motor

Model Predictive Current Control of Nine-Switch Inverter-Fed Six-Phase Induction Motor Drives Under Healthy and Fault Scenarios

An Enhanced Sliding Mode Speed Control for Induction Motor Drives

Loss Model Control for Efficiency Optimization and Advanced Sliding Mode Controllers with Chattering Attenuation for Five-Phase Induction Motor Drive

Modified Sliding Mode Observer-Based Direct Torque Control of Six-Phase Asymmetric Induction Motor Drive

Control with Sliding Mode of a Five-Phase Series-Connected Two-asynchronous Motor Drive

DSP based Implementation of Vector Controlled Induction Motor Drive using Sliding Mode Speed Control Strategy

A full sliding mode sensorless control of three-level inverter-fed induction motors

Nonlinear SVM-DTC for induction motor drive using input-output feedback linearization and high order sliding mode control