Abstract:The five‐phase six‐leg inverter is adopted for the fault‐tolerant control of the five‐phase PMSM, which can relieve the constraint of the zero neutral point current and improve the performance of the machine. The maximum torqu MT and MC current regulations are considered under different open‐circuit conditions, and their effectiveness are verified by the experiments. Five‐phase permanent magnet synchronous machine (PMSM) can operate under open‐circuit faults with the appropriate current regulations. However, the traditional current regulations based on the five‐phase half‐bridge inverter have to satisfy the constraint of zero neutral point current, which limits the fault‐tolerant performance of the machine. Thus, this paper investigates the current regulation based on the five‐phase six‐leg (FPSL) inverter, which relieves the zero‐neutral point current limitation, and both current regulations considering the maximum torque (MT) and minimum copper loss (MC) are derived under different open‐circuit conditions. The cost of the system has increased, but with the new regulations, better fault‐tolerant operation capability of the machine can be obtained under all kinds of open‐circuit faults. Moreover, with the introduction of the neutral point current, the machine can work under triple‐phase open‐circuit faults. In conclusion, the proposed control scheme based on the FPSL inverter expands the fault‐tolerant operation capability of the five‐phase PMSM. The experiment results prove the effectiveness of the proposed current regulation on increasing average torque or reducing copper loss under fault‐tolerant operation.

Variable speed Control under Voltage and Current Limits of a 5-phase PMSM drive in Healthy and Open-Circuited Modes

Comparative Study of Flux-Weakening Control Methods for Pmsm Drive over Wide Speed Range

A Sinusoidal Current Control Method for SPMSM Considering Uneven Demagnetization Fault

A Fault Tolerant Control Strategy for Dual Three-Phase PMSM under Single-Phase Open Circuit Fault Considering Inductance Asymmetry

Fault-Tolerant Control of Dual Three-Phase PMSM Based on Minimum Copper Loss under Multi-Phase Open and Open-Switch Faults

Control of Dual Three-Phase Permanent Magnet Synchronous Motor under Open Phase Fault Conditions

A V/Hz Based Maximum Torque Per Volt Control in Flux-Weakening Region for Interior Permanent Magnet Synchronous Motors

Single- and Two-Phase Open-Circuit Fault Tolerant Control for Dual Three-Phase PM Motor Without Phase Shifting

An I/f Control Method With Closed-loop Regulation of Current Vector for Surface Permanent Magnet Synchronous Motor Drives

Strategies for the fault-tolerant current control of a multiphase machine under open phase conditions

Adaptive Torque Ripple Suppression Methods of Three-Phase PMSM During Single-Phase Open-Circuit Fault-Tolerant Operation

Nonlinear Speed Sensorless Control Of Pmsm Drives

Fault‐tolerant operation for five‐phase permanent magnet synchronous machine drives with five‐phase six‐leg inverter

Fault-Tolerant Control of a Five-Phase Permanent Magnet Synchronous Motor for Industry Applications

Generalized Fault-Tolerant Model Predictive Control of Five-Phase PMSM Drives Under Single/Two Open-Switch Faults

Sensorless control for five-phase PMSMs under normal and open-circuit fault conditions using super-twisting sliding mode observers

Fault‐tolerant control of current residual vector three‐phase four‐switch motor drive system based on MLD model

An Embedded Fault-Tolerant Control Method for Single Open-Switch Faults in Standard PMSM Drives

Fault Tolerant Control of PMSM Drive Based on Voltage Sensor for Electric Vehicle Application

Single-phase Open-circuit Fault-tolerant Control for a Dual Five-phase Permanent Magnet Motor with Multi-operational Modes

Decoupled Modeling and Nonlinear Speed Control for Five-Phase PM Motor Under Single-Phase Open Fault