Abstract:Morphology development at the fiber/matrix interphase in fiber-reinforced isotactic polypropylene composites is a widely studied topic. While the application of shear flow may strongly enhance the nucleation density around the fiber, little is known about the influence of fibers on the crystallization of polypropylene subjected to an extensional flow. In this work, the flow around a single glass fiber upon uniaxial elongation of the melt is examined using X-ray scattering and diffraction techniques and compared to the response measured for the neat matrix. A comparison between a neat and compatibilized matrix is made given the strong influence of the addition of an adhesion modifier on the bulk crystallization kinetics of polypropylene. The flow is applied using an in-house-built filament stretching extensional rheometer, which, due to its midfilament control scheme, allows for in situ X-ray experiments. Combined small-angle X-ray scattering/wide-angle X-ray diffraction patterns are acquired during the flow and subsequent crystallization step. Postcrystallization area scans of the filament show that the introduction of a single glass fiber gives rise to the development of β-phase crystals, particularly in the area around the fiber ends, and in contrast to what is observed for the matrix materials alone, where solely α-phase is found. Surprisingly enough, the addition of a single fiber (0.00045 vol %) alters the crystallizing polymorph in almost the entire filament. However, the addition of the adhesion modifier hinders the formation of β-phase crystals around the fiber due to an acceleration of the bulk crystallization kinetics. Finite element simulations provide insight into the flow field around the fiber during stretching and demonstrate that the flow is no longer uniaxial extension, but dominated by shear, even though the volumetric amount of fiber as compared to the matrix is negligible. These findings explain the experimental observation of substantial β-phase formation after the introduction of a single fiber, while this is not observed in the matrix material. Worth noting, the formation of β-phase polypropylene depends not only on the presence and the strength of the flow but predominantly on the type of flow, i.e., shear as opposed to elongation.

Identify Kinetic Features of Fibers Growing, Branching, and Bundling in Microstructure Engineering of Crystalline Fiber Network

From Kinetic-Structure Analysis to Engineering Crystalline Fiber Networks in Soft Materials.

Molecular Dynamics Simulation of Chiral Carbon Nanothread Bundles for Nanofiber Applications

Time-Dependent Constitutive Behaviors of a Dynamically Crosslinked Glycerogel Governed by Bond Kinetics and Chain Diffusion

Numerical Study of Melt-Spinning Dynamic Parameters and Microstructure Development with Ongoing Crystallization

Microengineering of Supramolecular Soft Materials by Design of the Crystalline Fiber Networks

The evolution of crystalline structures during gel spinning of ultra-high molecular weight polyethylene fibers

Dynamic Responsive Formation of Nanostructured Fibers in a Hydrogel Network: A Molecular Dynamics Study

Modeling the Large Deformation and Microstructure Evolution of Nonwoven Polymer Fiber Networks

Tuning Bio-Inspired Skin-Core Structure of Nascent Fiber Via Interplay of Polymer Phase Transitions.

Mechanics of Network Materials with Responsive Crosslinks

Multiscale micromechanics modeling of viscoelastic natural plant fibers

Fiber-Induced Crystallization in Elongational Flows

Kinetically controlled homogenization and transformation of crystalline fiber networks in supramolecular materials

Modeling and characterization of the mechanical properties of nanofiber yarn

In situ experimental investigation of fiber orientation kinetics during uniaxial extensional flow of polymer composites

Rheological Study of Microstructures and Properties for Polymeric Materials

Molecular Modeling of the Microstructure Evolution during the Carbonization of PAN-Based Carbon Fibers

Microstructural Evolution during Dry-Jet Wet Spinning Postprocessing from Coagulation Bath Fiber to High-Performance Polyacrylonitrile Precursor Fiber

Crystallization and crystal morphology of polymers: A multiphase-field study

Effect of fiber orientation on spinning dynamics for liquid crystalline polymer solutions using mesoscopic theory